Transcript
AUDIO-CAP
I M PO RTANT WARN I N G S A N T I G R A V I T Y
B A T T E
R I
E S
ADVENTURE SERIES
IMPORTANT SAFETY INSTRUCTIONS
AUDIO-CAP WIRELESS BLUETOOTH BEAN I E WITH BUILD I N H EADPHON ES +LISTEN TO MUSIC AND AUDIO +ANSWER YOUR PHONE AND TALK +PLAY OR PAUSE MUSIC AND AUDIO +SKIP TO NEXT OR PREVOUS TRACK
U S E R M A N UA L
*Do not use this product in or near water. *Do not set next to or near any heated equiptment sources such as radiators, heat registers, stoves or other devices. *Only use attachments/accessories specified by the manufacturer. *Refer all servicing to qualified service personnel. *Servicing is required when the device has been damaged in any way such as liquid has been spilled or the device has been exposed to rain or moisture, and does not operate normally. *Batteries should not be exposed to excessive heat such as fire or heaters. Do not place any sources of danger on the device (e.g. liquid filled objects, flammable vapors, lighted candles). PLEASE DO NOT TRY TO REPAIR THE PRODUCT BY YOURSELF.
USE AS A BLUETOOTH AUDIO DEVICE The AUDIO-CAP can be paired with any Bluetooth enabled device and play music/audio and also answer incoming calls and talk via its built-in Mic. Additionally you can hang-up, play/pause audio, skip to the next or previous song, and raise or lower the volume all directly from the AUDIO-CAP’s Control Panel. 3) TURNING ON AND OFF a) To turn ON the AUDIO-CAP press and hold the Play/Pause Button for 3 seconds, a Blue LED will slowly flash indicating the AUDIO CAP is “ON”. b) To turn OFF press and hold the Play/Pause Button for 3 Seconds. Please note: Sometimes the fabric from the Beanie can cover the LED light-hole on the Audio Cap making it hard to see the LED. Adjust fabric over LED light to make it more viewable.
A N T I G R A V I T Y
4) PAIRING THE AUDIO-CAP a) Press the Play/Pause Button for 5 seconds; the AUDIO-CAP will enter “Pairing Mode” with a small red and blue LED light alternately flashing at the status light hole, indicating it is searching for device to pair with. b) Enter the Bluetooth Mode on your Phone or Device and scan for “audiocap” and select. When If paired correctly the blue light alone will flash slowly. 5) CONTROL AUDIO IN BLUETOOTH MODE a) Press the Play/Pause Button once to PLAY Audio and press again to PAUSE Audio. b) To skip to NEXT or PREVIOUS Track press the + or - Button one short press to skip forward or backward. c) To raise or lower Volume Press and HOLD the + or - Buttons until desired volume is achieved.
B A T T E
R I
E S
ADVENTURE SERIES
*NEVER LISTEN AT HIGH VOLUMES FOR A PROLONGED PERIOD. *Remove Earphones before Washing.
1) CHARGING THE AUDIO-CAP
C O N T R O L PA N E L
Thank you for purchasing the AUDIO-CAP by Antigravity Batteries. We are confident that this product will be the source of much enjoyment! Please read the following chapters carefully so that you can become acquainted with the advantages of this product and its use. The AUDIO-CAP can be used to listen to your music or audio and even allows you to take calls and talk back via Bluetooth. Just “pair” your phone with the AUDIO-CAP and do any activity while having full control over answering your phone, playing/pausing your music, raising/lowering the volume and even skipping to the next or previous song... all from the Control Panel located on the AUDIO-CAP!
6) PHONE CALLS IN BLUETOOTH MODE a) To answer a call, wait for the AUDIO-CAP to ring, then press the Play/Pause Button once to accept call. b) To hang up a call press the Play/Pause Button once after conversation has ended. c) To Re-Dial the last number called press the Play/Pause Button twice quickly. d) To reject incoming calls, hold the Play/Pause Button down for about 2 seconds to reject call. e) To adjust volume of Phone/Speaker press and hold + or Buttons to achieve desired volume.
-
- Button
-Controls Volume Down -Controls Prev. Song/Chapter
+ Button
-Controls Volume Up -Controls Next Song/Chapter
Status Light
blue/red LED lights
USB Charging Port
Play/Pause Button -Power On/Off -Play/Pause -Answer/Hang-Up Phone -Re-Dial -Bluetooth Conn/Pairing
located in small hole in beanie below Control Panel
TURN OFF THE DEVICE WHEN NOT IN USE TO SAVE BATTERY CHARGE!
TROU B LE SH OOTI N G
SPEC I F I CATI O N S NOTE: Specifications may be changed without notification. Battery
Rechargeable Lithium 130mah 3.7v
DC Power Input
USB 5V 500mah
Charge Time/Working Time
2-3 Hours
Battery Working Time
5-8 Hours Depending on Use
Transmission of Mic
1 Meter
Bluetooth Solution
CSR V4.1
Frequency
2.402Ghz- 2.480Ghz
Range of Operation
10 Meters (No Obstacles)
TIP: Remember, a long press to adjust the VOLUME, and a short press to SKIP to next or previous Track with + or - buttons. The effective operation range between the AUDIO-CAP and your Bluetooth device is approximately 10 meters (30 feet).
The AUDIO-CAP has a built-in Lithium-Ion Battery that can be charged by any USB Output using the included MICRO-USB Cable. The location of the Charging Port is at a small hole in the beanie’s fabric below the AUDIO-CAP Control Panel. a) Plug the Micro-USB Cable into the Micro-USB Charging Port on the AUDIO-CAP. You may have to move the fabric of the beanie around to locate the charging port. b) Connect the other end of cable to a USB Output Port such as those on your Computer, Laptop, Phone Charger, Vehicle or Charging station. c) The Power indicator light (red) is on when charging and turns off when fully charged. d) It takes roughly 2 to 3 hours to fully charge.
No Power- In most cases this is a drained battery or the device is not turned ON. Recharge or Turn On. Can’t see LED light- This can occur because the fabric can stretch or is not aligned with the LED light hole...you may have to move site-hole over control-panel behind the fabric to see the lights clearly. No Sound- Check that the unit is on, check that the volume has been turned up on your Device and the AUDIO-CAP. Check that the Wireless device is within range. Check that the Bluetooth is paired correctly with your Phone or other Device. Low Volume- Try aligning ear phones directly over your ears, or turn volume of your device up and then turn the volume of AUDIO-CAP up. No Bluetooth or bad operation- Turn off unit and on again to reset. This product is warrantied to be free from defects in material and workmanship for the period of one year. TURN OFF THE DEVICE WHEN NOT IN USE TO SAVE BATTERY CHARGE!
THAN K Y O U A N T I G R A V I T Y
B A T T E
R I
ANTIGRAVITY BATTERIES, LLC. • GARDENA, CA 90248 •
[email protected] • COPYRIGHT 2016 ALL RIGHTS RESERVED
E S
ANTIGRAVITY BATTERIES, LLC. GARDENA, CA 90248
[email protected] COPYRIGHT 2016 ALL RIGHTS RESERVED
