Preview only show first 10 pages with watermark. For full document please download

Audio-mixer_studer(4820dr

   EMBED


Share

Transcript

Studer Studer® OnAir 2500 / Vista Cable Connections 5. Press Com Type and use the Type knob to select the type of communications for your device. • OnAir 2500 — select RS-232. • The OnAir 2500 connects to the switcher over an RS-232 serial connection to a DB9 port on the switcher and a DB9 port on the device. The Vista connects to the switcher over a standard ethernet connection. 1 2 3 4 5 1 2 3 4 5 6 7 8 9 6 7 8 9 To Switcher To Device (male cable end) (male cable end) Figure 1: Switcher to OnAir 2500 Cable Vista — select Network TCP. 6. Press Com Type and use the Type knob to select the type of communications for the device. • OnAir 2500 — use the Baud and Parity knobs to select 38400 (Baud) and NONE (Parity). • Vista — use the Client/Server knob to select Client and enter the IP address of the device in the Remote IP Address field and 8087 in the Remote Port field. 7. Press Extra Options. Table 1: Switcher to OnAir 2500 Cable Connections Acuity™ (Remote Port) OnAir 2500 (RS-232 Port) 2 (Tx) 2 (Rx) 3 (Rx) 3 (Tx) 5 (Ground) 5 (Ground) Switcher Setup The switcher must be set up to communicate with the audio mixer using either serial or ethernet protocols, as well as associate the audio channels on the mixer with video sources coming into the switcher. To Set Up Communications 1. Press HOME > Setup > Installation > Com Setup. 2. Press Type and use the Com Port knob to select the remote port that you want to set up for the device. 3. Use the Device knob to select Audio Mixer. 4. Press Select Device and use the Device knob to select your device. • OnAir 2500 — select Studer. • Option Value OD Master M1 (default) Channel Label Switcher (default) 8. Press HOME > Confirm. To Set Up a Video Input Tip: Refer to your switcher Setup manual for information on setting up audio groups. 1. Press HOME > Setup > Installation > Source Config > Audio. 2. Use the Input knob to select the input source that you want to assign an audio channel or group to. 3. Use the Audio X knob to select the audio channel, or group, that you want to assign to the selected source. You can assign up to two channels or groups. 4. Press HOME > Confirm. Vista — select Vista. 4820DR-616 Rev.1 Device Setup The device must be set up to communicate with the switcher using the same serial or ethernet communications as you set the switcher up to use. Note: This information in this procedure is provided as a guide and is based on the current version of hardware and software that was available at the time of testing. For the most accurate and up-to-date information, refer to the documentation that came with your device. To Set Up Serial Communication for the OnAir 2500 The OnAir 2500 can have a variable number of input channels and has two program output channels. You must specify the number of input channels on your audio mixer as well as which output channel you wish to control with your switcher. To Set Up Ethernet Communication for the Vista The Vista must be set up for TCP communications on port 8087. 2