Transcript
DMX RECEIVER INSTRUCTIONS Theatrelight’s range of DMX Receivers are designed to decode DMX desks to control analogue dimmers. The Receivers are available in 24,48 and 64 channel sizes for Rackmount or Standalone use. For correct operation for all models, follow these steps:
SET DIMMER OUTPUT VOLTAGE AND POLARITY Select the correct output and polarity for your dimmers, The selector is located on the base of the Receiver, For example, if your dimmer specifies +10 volts as the correct operating voltage, set the ‘10V’ and ‘positive’ dip switches only to the ON po sition. Alternatively if the specifications are for -15 volts, set the ‘15V’ and ‘Negative’ dip switches only to the ON position. The ‘Diode Offset’ option is only required if your dimmers have been set up for older analogue desks.
DISCONNECT POWER BEFORE CHANGING THE OUTPUT VOLTAGE OR POLARITY SET THE START ADDRESS
For normal use set the start address to 001. Dimmer 1 is then controlled by Channel 1 from the desk and so on. When using two Receivers, for example two 24 Channel Receivers, set the Start Address of the second Receiver to 025 The Start Address can be any number from 1 to 512. It may be changed while the power is on.
CONNECT POWER AND DMX CABLES Connect plugpack power cable and DMX cable as pictured below and switch on. Correct operation is indicated by the Power and DMX LEDs. If the DMX LED does not light, check the polarity of all DMX cables.
BACK PANEL
CHANGE ONLY WITH POWER OFF ON FOR 15V ON FOR 12V ON FOR 10V
SET OUTPUT
ON FOR POSITVE ON FOR NEGATIV NO DIOE OFSET
VOLTAGE
DIOE OFSET
OUTPUT LEVEL/POLARITY SELECTOR WARNING CHANGE WITH DO
SET START
SETTINGONLYPOWEROFF
POSITVE AND NEGATIV TO NOTSETBOTHON
FRONT PANEL
ADRESS PIN 1 PIN 2 18 VOLTS AC PIN 3 ENTRC TAP
PIN 4 18 VOLTS AC
CHASIERT
(FLOATING)
PLUG PACK
POWER SUPPLY
POWER FROM
DMX -512 RECEIVER
PIN 1 CRENS PIN 2 ATD PIN 3 ATD
POWER
SIGNAL
_
+
1
_
OUTPS 1 _
24 _ 24
OUTPS 25 _
EARTH
25
_ _
OUTPS 48 _
48 48
49
_ _
64
64
EARTH
STAR ADRES
DMX LINK
TO OTHER DMX DIMMERS OR DMX CONTROLLED DEVICES (e.g. MOVING LIGHTS)
MODEL TLRX64 S DMX-512 SIGNAL INPUT
DMX CABLE FROM CONTROL DESK
0 MANUFCTRED BY
0
1
SELCT OUTP LEV AND POLARITY ON BASE
THEATRELIGHT
LTD
AUCKLND NEW ZEALND
TO DIMMER RACKS (MULTICORE CABLE) APPLIES TO MODELS: TLRX24/S,TLRX24/R, TLRX48/S,TLRX48/R, TLRX64/S,TLRX64/R
YOUR AGENT 6 ROWE STREET,ONEHUNGA P.O.BOX 13-159,AUCKLAND,NEW ZEALAND TELE: :64 9 6221187, FAX:64 9 6365803
EARTH
