Transcript
Installation Instructions
M15650 Scru-Band Kit
Scru-Band Kit Installation Instructions A. Before cutting band, insert roll band end through housing front entrance (Figure 1). Pull band out through back (Figure 2). Allow ample band length. Insert band end into side entrance of housing (Figure 2) forming an oversized diameter clamp. For best clamping results on large diameter clamps, allow approximately 11/4” band length past back of housing (Figure 2). (Less for smaller diameters).
Figure 1
Pull clamp diameter snug around object to be clamped. Insert screw into front entrance, tighten and cut off band (Figure 3).
B. On applications where it is desirable to minimize the length of band between housing and cut-off end (Figure 3), pull clamp diameter snug around object, mark band even with front entrance of housing, remove band and housing from object, cut band in marked location. Reinsert cut band end through back of housing, insert screw and tighten.
Figure 2
C. On applications where the end of object to be clamped can’t be reached (such as utility poles), add housing to the band as described above, wrap free end of band around object and follow step “A” to finish application.
Figure 3 BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925
WWW.CABLEJOINTS.CO.UK
THORNE & DERRICK UK TEL 0044 191 490 1547 FAX 0044 477 5371 www.BAND-IT-IDEX.com TEL 0044 117 977 4647 FAX 0044 977 5582 WWW.THORNEANDDERRICK.CO.UK
Page 1 of 1
Document # M15650 Rev. © Copyright BAND-IT-IDEX, Inc. 2007 All rights reserved
