Preview only show first 10 pages with watermark. For full document please download

Basic Adaptor Sockets Kit

   EMBED

Share

Transcript

LightwaveRF connect Basic Adapter On/Off Socket Operation Manual Model No: JSJS LW380 It is important to install this product in accordance with the fitting instructions below. Failure to do so may render your guarantee void. IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE AND FOR GUIDANCE ON THE ASSOCIATION OF REMOTE HANDSETS. FOR HELP AND SETUP GUIDANCE PLEASE VISIT www.lightwaverf.com OVERVIEW: SETUP Pairing using LEARNING MODE: 1.Ensure the adaptor is plugged in and ready with the wall socket turned on. 2. Once plugged into the wall the adaptor will enter LEARNING MODE for a duration of 5 seconds, this will be illustrated by the red LED flashing on and off. 3. Whilst the adaptor is in learning mode, press the desired ‘ON’ button on the remote; the LED on the adaptor will stop blinking and any lamp plugged in and turned on will flash twice to indicate that it is paired. NOTE: Learning Mode lasts for only 5 seconds; if no signal is received from a remote handset during this time then the adapter will automatically exit learning mode without pairing the device. Unpairing Remotes and clearing the Switch memory Removing single device: 1. Remove the plug adaptor from the wall socket and after 5 seconds replace it. 2. Once plugged into the wall the adaptor will enter LEARNING MODE for a duration of 5 seconds, this will be illustrated by the red LED flashing on and off. 3. Whilst the adaptor is in leaning mode, on the Remote press the ‘OFF’ buttons of the paired channel that needs to be unpaired; the LED on the adaptor will stop blinking and any lamp plugged in and turned on will flash twice to indicate that it is un-paired. OPERATION Switch ‘ON/OFF’ with Remote Handset Press ‘ON’ on the handset to turn on adaptor(s) paired to the selected channel. Press ‘OFF’ on the handset to turn off adaptor(s) paired to the selected channel. NOTE: One channel can be programmed to turn on more than one socket with a single key press to create a group. Changing the Remote Battery 1. Pull out the battery holder. 2. Remove old battery and replace with a fresh one. 3. Replace battery holder into transmitter NOTE: • Connect correctly and securely • Do not recharge • Keep away from children • Do not swallow (If swallowed, seek medical advice immediately) • Please dispose of used batteries responsibly SPECIFICATION RF frequency: 433.92 MHz Input rating : 220-230V~ 50Hz Load : 13A Birmingham Science Park Aston Faraday Wharf Holt Street Birmingham B7 4BB Tel: 01902 500 562 Email: [email protected]