Transcript
75.5137.02
BROWN STAL COM . 16,18 13 GREY RED 5 RED 3, 6, 8 RTN WHITE YELLOW 1, 8 TB3-3 15
LO-LINX
-
RED
LO-LINX EAGLE HARNESS p/n: 20.5096
INCR.
FUNCT.
12-24V AC/DC
STALL COM
ACTIV. SAFETY STALL
SFTY / ACT COM
HOLD AUTO GND
N/O
LO-LINX POWER HARNESS p/n: 20.5095
AUTO
RED BLACK
OFF
WHITE
COM
N/O
Pre-wired switch assembly
HOLD OPEN
LO-LINX HOLD SWITCH HARNESS p/n: 20.5078
CUP MASTER
V6.3+ ONLY
CUP SLAVE
BROWN
GREEN
WHITE
BLACK
BLUE
BODYGUARD 2
KILL
KILL
YELLOW
BROWN
DOOR MTD SENSOR APPROACH SIDE
6
7
8
COM
POWER
POWER
RED
5 N.O.
BLACK
4 N.C.
WHITE
GREEN
3
INHIBIT GND 2
INHIBIT +
1 EMPTY
RED
8 POWER
BLACK
7 POWER
WHITE
6
GREEN
5 N.O.
4
COM
3
1 EMPTY
INHIBIT +
8 POWER
N.C.
7 POWER
DOOR MTD SENSOR SAFETY SIDE
INHIBIT GND 2
6 COM
RED
5 N.O.
BLACK
4 N.C.
WHITE
GREEN
3 INHIBIT +
1 EMPTY
DOOR MTD SENSOR APPROACH SIDE
INHIBIT GND 2
8
RED
7 POWER
POWER
BLACK
5
WHITE
SYNC CABLE
6
GREEN
SETUP
LO-LINX SUPERSCAN HARNESS p/n: 70.5071
N.O.
4 N.C.
RED
BODYGUARD 1
COM
3
INHIBIT GND 2
INHIBIT +
PWR
WHITE SEE NOTE #4 BLUE
BROWN
WHITE
GREEN
RED GREEN
WHITE
BLACK
RED
1
TO CTRL
SEE NOTE #2
EAGLE 2
SEE NOTE #4
EMPTY
SWITCH
24 V TRANSFORMER
GREEN BODYGUARD (Y) HARNESS USED FOR DUAL-EGRESS APPLICATIONS BLACK
GREEN
WHITE
BLACK
EAGLE 1
*
RED
SEE NOTE #1
LO-LINX CONTROL HARNESS p/n: 20.5097
RED
BLUE
+
BEAM TX RX
COM
BODYGUARD
AUX
LO-LINX BODYGUARD HARNESS p/n: 20.5082
DOOR MTD SENSOR 2
EAGLE 2
DOOR MTD SENSOR 1
SENSORS EAGLE 1
STALL STALL 2
MTR
LO-LINX MOTOR HARNESS p/n: 20.5076
DC MOTOR
BLACK
RED STALL 1
GREEN WHITE YELLOW BLUE ACT. COM . SAF. STALL 13 12 11 15, 17 3 4 9 5 YELLOW GREY BLUE PURPLE BLACK RED WHITE WHITE 6 BLACK 5 RED 4 WHITE 3 VIOLET 2 3, 6, 8 4 10 ACT. RTN SAF. 1 SAF. 2 GREEN WHITE RED YELLOW ORANGE YELLOW RED BLUE 2 1, 8 7 7 TB4-4 TB4-3 TB3-8 TB3-4 5 4 18 14
MOTOR
LO-LINX SWING BESAM 300 BESAM M/P DOM GT 300/400 GT MAG HORTON 4190 HUNTER KM K STANLEY "L" STANLEY M/P STANLEY 521 TORMAX TTXII
DOOR MTD SENSOR SAFETY SIDE
NOTES: 1. MOTOR CONNECTION IS TIED IN PARALLEL TO EXISTING MOTOR LEADS. NO RESPECT TO PALARITY IS REQUIRED. 2. THE KNOWING ACT SWITCH IS CONNECTED AT THE AUX INPUT AND CAN BE ANY DRY CONTACT DEVICE SUCH AS A PUSHPLATE, CARD READER, ETC. THE AUX INPUT IS REQUIRED FOR ALL INITIAL ACTIVATION WHEN FUNCTION 'FA' ON THE LO-LINX IS SET TO '01'. 3. SET CONTROL FUNCTION WITH PMD 13=a,14=a,16=0,17=0,18=0,19=b,20=a. F11= DEGREE AT WHICH TO IHIBIT SWING SIDE SUPERSCAN DEPENDING ON APPLICATION 65-75 DEGREES TYPICAL. 4.THE SECOND BODYGUARD AND EAGLE ARE PRIMARILY USED IN DUAL-EGRESS APPLICATIONS. ENSURE TO SET THE BODYGUARD RELAY VALUE TO 2. IF AFTER TROUBLESHOOTING A PROBLEM, A SATISFACTORY SOLUTION CANNOT BE ACHIEVED, PLEASE CALL B.E.A., INC. FOR FURTHER ASSISTANCE DURING EASTERN STANDARD TIME AT 1-800-523-2462 FROM 8AM - 5PM. FOR AFTER-HOURS, CALL EAST COAST: 1-866-836-1863 OR 1-800-407-4545 / MID-WEST: 1-888-308-8843 / WEST COAST: 1-888-419-2564. DO NOT LEAVE ANY PROBLEM UNRESOLVED. IF YOU MUST WAIT FOR THE FOLLOWING WORKDAY TO CALL B.E.A., LEAVE THE DOOR INOPERABLE UNTIL SATISFACTORY REPAIRS CAN BE MADE. NEVER SACRIFICE THE SAFE OPERATION OF THE AUTOMATIC DOOR OR GATE FOR AN INCOMPLETE SOLUTION.WEB: WWW.BEASENSORS.COM
100 ENTERPRISE DRIVE PITTSBURGH, PA 15275 PHONE: (412) 249-4100 FAX: (412) 249-4101 EMAIL: www.beasensors.com
TITLE: BESAM DUAL CUP/MP V.6.3+ LO-LINX SYSTEM SIZE: A
DRAWN BY: REV BY: JED TUC SCALE: DATE: NONE 10/15/2007
PART NO:
80.0280.01 SHEET 1 OF 1
