Transcript
Accessory
INSTALLATION INSTRUCTIONS PARTS LIST Front gold "A" emblem
Application
Publications No.
BII 25339
GOLD EMBLEM P/N 08F20-SEP-200
TL
Issue Date
SEP 2003
TOOLS AND SUPPLIES REQUIRED Phillips screwdriver 8 mm and 10 mm Sockets Ratchet Shop towel Masking tape
Rear gold "A" emblem
Isopropyl alcohol Flat-tip screwdriver Blanket
Rear gold "ACURA" emblem
Diagonal cutters Kite string INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
Rear gold "TL" emblem
NOTE: • Be careful not to damage the body paint.
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
•
This emblem kit should only be installed if the ambient air temperature is 60°F (15°C) or above.
•
To allow the adhesive to "cure", do not wash the vehicle for 24 hours.
Bll 25339 (0309)
08F20-SEP-2000-91
1 of 5
Installing the Front "A" Emblem 1.
4.
Remove the two bolts that secure the left front bumper strake to the bottom of the front bumper and remove the bumper strake by sliding it sidewise.
Remove the right side engine compartment cover (three pins and three tabs). TABS (3) RIGHT SIDE ENGINE COMPARTMENT COVER
FRONT BUMPER FRONT
PINS (3)
LEFT FRONT BUMPER STRAKE
3326010T
BOLT
3619020Y
2.
Repeat step 1 to remove the right side bumper strake.
3.
Remove the left side engine compartment cover (two pins and two tabs). TABS (2)
5.
Open the engine hood. Remove the front bulkhead cover (three clips, two screw clips and two pins).
SCREW CLIP
BATTERY COVER
CLIP
SCREW CLIP
PINS (2)
PIN
3619010Y
2 of 5
Bll 25339 (0309)
FRONT BULKHEAD COVER
3310011Y
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
6.
On each side fold down the front inner fender, and remove the front bumper (ten clips, two bolts and two self-tapping screws ). To prevent damage, set the bumper on a blanket during installation of the emblem.
8.
Remove the two self-tapping screws that secure the existing "A" emblem and remove the emblem. "A" EMBLEM
FRONT INNER FENDER
EMBLEM BASE
Fold down.
SELFTAPPING SCREW
SELFTAPPING SCREWS (2)
CLIPS (10) FRONT BUMPER
7.
BOLT (2)
9.
3326041T
Slide the pins on the gold "A" emblem into the holes in the emblem base and install the two selftapping screws you just removed.
3326022T
FRONT GOLD "A" EMBLEM
Remove the center molding (five self-tapping screws). SELF-TAPPING SCREWS (5)
EMBLEM BASE
3326051T
SELF-TAPPING SCREW
(Reuse.) CENTER MOLDING
FRONT BUMPER
9.
Reinstall all removed parts. Check that front bumper clips are installed securely.
3326030T
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
Bll 25339 (0309)
3 of 5
Installing the Rear "A", "ACURA" and "TL" Emblems
11. Remove the original emblems by cutting the outer edges with a piece of string. Note the location of the retaining pins on the back of original "A" emblem when cutting the edges.
10. To prevent damage to the paint and to help you position the gold emblems, attach masking tape around the original rear "A", "ACURA" and "TL" emblems.
KITE STRING
"A" EMBLEM KITE STRING
MASKING TAPE
"ACURA" EMBLEM
"TL" EMBLEM
MASKING TAPE
MASKING TAPE 3326061T
KITE STRING
3326071T
12. Remove the original "A", " ACURA " and "TL" emblems.
4 of 5
Bll 25339 (0309)
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
13. If any clip(s) for the "A" emblem remains on the vehicle body panel, remove the clip(s) with long nose pliers.
MASKING TAPES AROUND REAR “H” EMBLEM
14. Using isopropyl alcohol on a shop towel, thoroughly clean the areas where the new gold emblems will attach. 15. Remove the adhesive backings from the gold "A", "ACURA" and " TL " emblems and attach them to the trunk lid so they line up with the tape. Hold the gold emblems firmly against the trunk lid with the palm of your hand for 30 seconds.
ADHESIVE BACKING
GOLD "ACURA" EMBLEM
MASKING TAPE
GOLD "A" EMBLEM ADHESIVE BACKING
LONG NOSE PLIERS
ADHESIVE BACKING CLIPS
(Discard.)
MASKING TAPE
GOLD "TL" EMBLEM
3326081T
16. Remove the masking tape installed around the emblems in step 10.
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
Bll 25339 (0309)
5 of 5
