Transcript
BOP-4000 Front View Friday, May 06, 2011
Each audio input can be configured for either balanced or unbalanced AES audio by connecting 75 ohm cable to the input BNC OR 3 wire audio cable to the terminal block.
CLEAN OUT NOT USED NOT USED
Relay closures occur between point A and B for each of the 21 relays. Operation of the relay(s) is determined by system programming. NOT USED Time Code Input
NOT USED Each audio output can be configured for either balanced or unbalanced AES audio by connecting 75 ohm cable to the output BNC OR 3 wire audio cable to the terminal block. The format must also be selected by setting the jumper on the opposite side of the panel.
NOT USED
NOT USED
Page 1
BOP-4000 Rear View Friday, May 06, 2011
Set each of the 16 jumpers for either balanced or unbalanced.
To Additional Breakout Panel
9 Pin
To Additional Breakout Panel
26 Pin
Time Code - 1 Per Chassis
Relay Cables (2) - 26 Pin - 2 Per Channel
Serial ‘octopus’ cable - (2) per chassis Customer Service 800-447-7204
Page 2
