Transcript
Fibre Optic Video Transmitters and Receivers
BREAK-MFTS and BREAK-FRS
These transmitters and receivers are designed for video transmission over standard multimode and singlemode cables at distances up to 15 km.
Versatile Power Supply The video transmitters and receivers do not require any external stabilizer or rectifier and can be supplied with DC or AC in a very wide range.
MFTS and FRS - BOX The MFTS-BOX transmitters are designed and intended for installation in confined spaces such as outdoor camera housings. PLUG AND PLAY installation. The FRS-BOX receivers can be screwed to a flat surface or snapped shut on the 35 mm DIN bar.
(x)MFTS and (x)FRS - DIN/24 The DIN modifications are designed to be snapped shut into the 35 mm DIN bar (24VAC supply).
Videosignal Detector The FRS receivers contain videosignal detector with relay NOC contact and LED.
Overvoltage Protection at All Inputs and Outputs All the inputs and outputs are provided with fine excess-voltage protections to ensure high resistance of the video transmitters and receivers against excess-voltage and other interfering influences.
(x)MFTS and (x)FRS - RACK/24 The RACK modifications are designed to be installed into 19´´ racks BREAK-RACK.
MADE IN THE CZECH REPUBLIC
Available Modifications 820nm - multimode
Available Modifications 1300nm - multimode
Available Modifications 1300nm - singlemode
270-010 BREAK-MFTS-BOX*
270-011 BREAK-MFTS-BOX/1300*
270-012 BREAK-MFTS-BOX/1300SM*
280-010 BREAK-FRS-BOX*
280-011 BREAK-FRS-BOX/1300*
280-012 BREAK-FRS-BOX/1300SM*
270-110 BREAK-MFTS-DIN/24
270-111 BREAK-MFTS-DIN/24/1300
270-112 BREAK-MFTS-DIN/24/1300SM
280-110 BREAK-FRS-DIN/24
280-111 BREAK-FRS-DIN/24/1300
280-112 BREAK-FRS-DIN/24/1300SM
270-120 BREAK-2MFTS-DIN/24
270-121 BREAK-2MFTS-DIN/24/1300
270-122 BREAK-2MFTS-DIN/24/1300SM
280-120 BREAK-2FRS DIN/24
280-121 BREAK-2FRS DIN/24/1300
280-122 BREAK-2FRS DIN/24/1300SM
270-130 BREAK-3MFTS-DIN/24
270-131 BREAK-3MFTS-DIN/24/1300
270-132 BREAK-3MFTS-DIN/24/1300SM
270-210 BREAK-MFTS-RACK/24
270-211 BREAK-MFTS-RACK/24/1300
270-212 BREAK-MFTS-RACK/24/1300SM
280-210 BREAK-FRS-RACK/24
280-211 BREAK-FRS-RACK/24/1300
280-212 BREAK-FRS-RACK/24/1300SM
270-220 BREAK-2MFTS-RACK/24
270-221 BREAK-2MFTS-RACK/24/1300
270-222 BREAK-2MFTS-RACK/24/1300SM
280-220 BREAK-2FRS RACK/24
280-221 BREAK-2FRS RACK/24/1300
280-222 BREAK-2FRS RACK/24/1300SM
270-230 BREAK-3MFTS-RACK/24
270-231 BREAK-3MFTS-RACK/24/1300
270-232 BREAK-3MFTS-RACK/24/1300SM
260-014 FIBRE-4000*
260-015 FIBRE-4000/1300*
260-016 FIBRE-4000/1300SM*
(set transmitter + receiver)
(set transmitter + receiver)
(set transmitter + receiver) *ITI - TÜV certificate
METEL s.r.o. - Říkov 5 - 55203 Česká Skalice -
[email protected] - www.metel.cz
1.10
Rev:15-3-2003
Fibre Optic Video Transmitters and Receivers
BREAK-MFTS and BREAK-FRS MFTS
Specification
Value
Video IN
Input level Frequency responce Input connector Overvoltage protection Wavelength Modulation Output connector Signal / noise ratio
1 Vpp 75 Ω 5-10 M Hz signal input - male BNC connector + 30cm coax. cable 500 W 10/1000 µS 820 (1300) nm (.../1300) amplitude ST 60 dB
Wavelength Modulation Input connector Distance trasmit./receiver
820 (1300) nm (.../1300) amplitude ST 820nm: 1 - 4000 m MM - 820nm / Max. 14dB 1300nm: 1 - 5000 m MM - 1300nm / Max. 14dB 1300nm: 1 - 15000 m SM - 1300nm / Max. 14dB female BNC 5-10 M Hz typ. 54 dB NO/NC contacts - 60VAC/0,5A or 60VDC/1A 5/2 ms
Video OUT
Unit
Comment
FRS Video IN
Video OUT
Output connector Frequency responce Signal / noise ratio Relay-videosignal detection Switch on / switch off
MFTS (FRS) MFTS(FRS)-BOX 62,5/125 or 50/125 Multimode µm MFTS(FRS)-BOX/1300 62,5/125 or 50/125 Multimode µm MFTS(FRS)-BOX/1300SM 9/125 Singlemode µm DC 10.8 - 18 V AC 10 - 16 V Frequency 45 - 65 Hz 24 V DIN or RACK AC (45-65Hz) Consumption / 12VDC 45 / 70 mA MFTS / FRS Overvoltage protection 600 W 10/1000 µS o -20 … +50 C Temperature Humidity max.95 (non-condensing) % W/H/L 68 x 28 x 120 mm Including connectors BOX: with DIN locks 52 mm Including connectors Housing material Al plate kg Weight approx. 0.1/0.2 MFTS-BOX/FRS-BOX RACK/24 up to 20 modules can be installed in 19´´rack BREAK-RACK DIN/24 (W / H / L) 153 x 70 x 126 mm Excluding BNC connectors EMC, EMI, safety EN 60065, EN 55022, EN 61000-4-2, EN 61000-4-4, EN 61000-4-5 Certificates ITI - TÜV, TESTALARM Praha ITI - TÜV - group Süddeutschland
Fibers
Supply
Environment Enclosure
Norms
Due to Metel´s continuous improvement of products the specifications are liable to change without notice.
VIDEO IN
2MFTS=2xMFTS 3MFTS=3xMFTS
VIDEO OUT
820 NM (1300NM)
2FRS=2xFRS ALARM NO/NC
BREAK-MFTS-... BREAK-MFTS-.../1300 BREAK-MFTS-.../1300SM
GAIN
BREAK-FRS-... BREAK-FRS-.../1300 BREAK-FRS-.../1300SM
METEL s.r.o. - Říkov 5 - 55203 Česká Skalice -
[email protected] - www.metel.cz
1.10
Rev:15-3-2003
Fibre Optic Video Transmitters and Receivers
BREAK-MFTS and BREAK-FRS xMFTS-RACK - front view
xMFTS-DIN - front view
OUT
1xMFTS
IN OUT
1xMFTS
IN
1xMFTS 1xMFTS 1xMFTS
OUT
xFRS-RACK - front view
OUT
IN
OUT
IN
Supply 24VAC
OUT
IN Supply 24VAC from 19´´ rack BREAK-RACK
IN
1xMFTS
xFRS-DIN - front view
OUT
1xFRS
1xFRS
IN
1xFRS
OUT
1xFRS
IN
OUT
IN
OUT
Supply 24VAC
IN
Supply 24VAC from 19´´rack BREAK-RACK
METEL s.r.o. - Říkov 5 - 55203 Česká Skalice -
[email protected] - www.metel.cz
1.10
Rev:15-3-2003
