Brochure - Imob Solar Battery Chargers

Transcript

Free to be Off the Grid >> IMOB™ Solar Battery Chargers HOW TO USE THE IMOB iMob Solar Battery Chargers convert light energy from the sun into 12 volt DC electricity, which is then transported to the rechargeable batteries through the lead wire and connector. 88 Industrial Auto Renewable Marine Auto Energy Industrial Marine Fleet RV/Camping Renewable Industrial Energy Performance Renewable Fleet Energy RV/Camping Home Fleet Performance RV/Camping Bus Performance Home Golf Home Farm Bus ISC400>> ISC1000>> Battery Not included 90° Step 1. - Face the front (black) side of the solar panel to the sun and make sure there is no shadow cast on the solar panel. It is best to place the long side of the panel at a South to North direction. Step 2. - Tilt the iMob at a suitable angle. This should be a right angle and be similar to your local latitude. Step 3. - Plug in the LED connector. The light should turn on verifying that the solar panel is generating electricity. Then disconnect connector and proceed with remainder of installation. Step 4. - If permanent installation is required, use stainless steel screws for mounting. 5.5 W, 400mA iMob Solar Battery Charger 2.2 W, 175mA iMob Solar Battery Charger 1.8 W, 125mA iMob Solar Battery Charger iMob Accessories ISCC1>> 15 W, 1Amp iMob Solar Battery Charger ISCC2>> Easily connect up to four (4) iMob solar panels for more power using 4 in 1 Connector & Charge Controller 1 Features: • Works in all weather conditions • Waterproof, shock and rust resistant • Reverse charge protection • Overcharge protection Marine ISC175>> Battery Shown for Scale Only The thin film amorphous technology of iMob’s panel allows the absorption of a wider spectrum of natural light and therefore works in cloudy weather conditions. This technology also enables the solar panel to handle the intense heat of the summer and the power loss due to rising temperatures. Auto ISC125>> * Cigarette Lighter Plug 2 2 ** Battery Clamp Air Flow Step 5. - If you need to dissipate heat from the unit, use a heat resistant spacer between panel and the surface. Bus Golf Farm Golf Farm Step 6. - This iMob comes with several different connectors. Choose the connector that fits your application. When using the battery clamps, make sure that you connect to the correct battery terminal. The black clamp indicates negative (-) and should be clamped on the negative terminal. The red clamp should be clamped on the positive (+) terminal. For cigarette lighter plug applications, push the plug into the female cigarette lighter socket and make sure that both ends are secure. 1 12 V 7A iMob Charge Regulator iMob 4 in 1 Connector Recommened for use with ISC1000 Recommened for use with ISC400 and ISC1000 89