C5040 Telematics Communicator

Transcript

INSTALLATION PROCEDURE This system must be installed by a professional. C5040 TELEMATICS COMMUNICATOR 4 PIN (WHITE) - DBALL 2 - Autostart Pager Port (with adapter #xxxx) - ASD-200 C5040 CAR STARTER or BYPASS 1. CONNECT Horn (GREEN) + Ignition (YELLOW) 4 PIN (BLUE) - AKX - iDatastart - EVO-ALL - ADS-AL-CA - Compustar - DSE TxRxData (BLUE) 4 PIN (BLACK) - EVO-ALL RxTxData (WHITE) RF DECODER INPUT Ground (BLACK) +12V Battery (RED) PAGER PORT / TRIGGER START (-) Installation: Place antenna 3 inches (minimum) from any obstructions +12V BATTERY* GROUND* + IGNITION HORN* Antenna: Cord length 9 feet Orientation: Vertical; antenna facing downwards (as seen in diagram) 2. PROGRAM 3. VALIDATE 4. CONFIGURE a. Connect the C5040 unit a. Disconnect the C5040 unit a. Install the smartphone app b. Wait for the start up sequence b. Turn ignition ON c. Press and hold button for 5 seconds (the green LED will blink 3 times) c. Connect the C5040 unit b. Create customer login (if one does not already exist) c. Go to “Add vehicle” d. The blue LED will blink according to the selected protocol: d. Wait for the start up sequence e. The C5040 will now be in “Installer Mode” for 15 seconds and the blue LED will blink slowly d. Enter activation code e. Registration completed f. During this time, turn ignition OFF to send an UNLOCK command to confirm programming 5. DELIVER i. ADS (default) ii. Fortin iii. Xpresskit iv. Smart Start (PolarStart version H7.0 V6.0 +) v. Polarstart Pager Legacy vi. Trigger Start (-) e. Briefly press the button to change the protocol f. Press and hold the button for 2 seconds to save the selected protocol g. For Fortin only (learning procedure) : i. Follow the remote car starter instructions to activate the transmitter learning mode ii. While the blue LED is blinking on the C5040 unit, briefly press the programming button to send a LOCK command to the remote car starter iii. The C5040 unit should now be registered with the remote car starter iv. Exit the remote learning mode of the remote car starter h. The C5040 unit is now in “operation” mode. g. The C5040 unit is now in “operation” mode. PIT-STOP MODE « OPERATION » Action / Event Move the vehicle to an open space outside and turn ignition off to allow the system to register in the network. LED Display Start-up sequence Red, Green and Blue LED are ON sequentially Command to remote car starter succeeded Fast blink of the Green LED during 1 second Command to remote car starter failed Fast blink of the Red LED during 1 second Button pressed briefly 1 blink of the Green LED Button pressed during > 2 seconds 2 blink of the Green LED Button pressed during > 5 seconds 3 blink of the Green LED If your car starter supports the “Pit-Stop” mode: 1. While your vehicle is parked and your motor is idling, press and hold the button for 2 seconds (the green LED will blink 2 times). The C5040 unit will send a START command to the car starter while the motor is running. This will activate the “Pit-Stop” mode. 2. Pull out the key and get out of the vehicle (the motor still running). *OPTIONAL This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. 6