Preview only show first 10 pages with watermark. For full document please download

Cecilware Wire Shelves Assembly Instructions

   EMBED

Share

Transcript

5. Lift the next shelf up and onto the four tubes sliding them through the corner holes of each shelf. Carefully slide the shelf down upon the sleeves (as in Figure 5). Figure 5 6. Repeat 4 and 5 for the next two shelves. Your system is now ready for use. Screw the plastic stand into the bottom to avoid scratching floor. CAUTION: ¾ DO NOT STAND ON OR CLIMB ON THE SYSTEM. ¾ DO NOT DROP HEAVY ITEMS ON THE SYSTEM SHELVES. ¾ DO NOT PLACE LIGHTER ITEMS ON LOWER SHELVES AND HEAVIER ONES ON TOP. ¾ DO NOT MOVE SYSTEM WHILE LOADED. Cecilware Corporation 43-05 20th Avenue Long Island City, NY 11105 Tel: 800-935-2211 Fax: 718-932-7860 www.cecilwarephotos.com Page 3 of 3 Cecilware Wire Shelving System Assembly Instructions (Typical Four-Shelf Unit Shown) Parts List: 1. Tubes 4 pieces 2. Plastic clips 16 Pairs 3. Shelves 4 pieces 3. Once all four tubes have been slipped into a shelf, set the system upright, and press the bottom shelf firmly onto the clips (as in Figure 3). Assembly Instructions: 1. Select the desired height for the shelf. Shelves can be placed at any of the 1” circular grooves along the tube. Now take a pair of plastic clips into the groove you have selected, small side up (as in Figure 1). 4. Select the placement of your next shelf by counting up the grooves to the desired height. Snap on other clips and repeat for each tube (as in Figure 4). NOTE: The shelf will not set properly if all the clips are not at the same level. Figure 1 2. Holding a shelf on its side, slide the tube from the bottom of the shelf through one of the corner holes (as in Figure 2). The plastic clips will slide nicely into the shelf creating a “double wedge”. Page 1 of 3 Figure 3 Figure 4 Figure 2 Page 2 of 3