Transcript
CIB 3130 502B Headset Adapter
CIB 3130 Issue 1
CIB 3130 502B Headset Adapter The 502B headset adapter allows you to use a headset with a 10-, 22-, and 34-button voice terminal with your System 25 or MERLIN® II Communications System. This headset adapter (Figure 1) comes with a D8AC modular cord and may be used to connect a headset with a 2prong plug or a modular plug. This headset adapter provides the ability to answer calls automatically without lifting the handset. For further information, refer to “Operating the Headset Adapter.”
LED indicator
On/Quiet button
Off button
Headset jack (for 2-prong plug)
FIGURE 1 502B Headset Adapter
iss1, cib3130-1
Installing the Headset Adapter Use the following instructions to install the headset adapter: 1
Place the headset adapter near the voice terminal to which it will be connected.
2
If your headset has a 2-prong plug, insert it into the headset jack on the front of the adapter (Figure 2).
LED indicator
On/Quiet button
Off button
FIGURE 2 Connecting a Headset with a 2-Prong Plug
3
If your headset has a modular plug, insert it onto the smaller jack on the rear of the adapter (Figure 3).
iss1, cib3130-2
Off button On/Quiet button
Terminal jack LED indicator Headset jack (for a modular plug)
FIGURE 3 Connecting a Headset with a Modular Plug
4 Plug one end of the modular D8AC cord (provided with the adapter) into the larger jack on the rear of the adapter (Figure 3). 5 Plug the other end of this modular cord into the jack labeled OTHER on the bottom of the voice terminal (Figure 4).
iss1, cib3130-3
10-Button voice terminal (bottom view)
To station jack
LINE jack
On/Quiet button
Modular (D8AC) cord Off button
OTHER jack
Headset (with a 2-prong plug)
FIGURE 4 Connecting Headset Adapter to Your Voice Terminal
OPERATING THE HEADSET ADAPTER The 502B headset adapter allows you to answer calls automatically or manually. Before you can use the automatic answering feature with your headset adapter, you must program a button on your voice terminal for Auto-Answer (Auto-Answer All for MERLIN II system users). For programming instructions, refer to the administration information that came with your system. NOTE: If you disconnect your headset plug from the headset adapter while a call is in progress, the call will be disconnected.
iss1, cib3130-4
Automatic Features To:
Do This:
Activate auto-answer feature
Press the programmed Auto-Answer button on your voice terminal. The green light next to the button goes on.
Answer a call
When you hear a beep and the Headset indicator goes on, begin speaking.
Disconnect a call
Calls automatically disconnect when the caller (far-end) hangs up. This feature is available only to System 25 users. MERLIN II system users must manually disconnect calls by pressing OFF.
Deactivate auto-answer feature (manual operation)
Press the programmed Auto-Answer button on your voice terminal. The green light next to the button goes off.
Manual Operation To:
Do This:
Place a call
●
●
Press On/Quiet. Listen for the intercom dial tone. Dial number.
Answer a call **
●
Press On/Quiet.
Disconnect a call
●
Press Off.
●
Other Features To Switch From:
Do This:
Handset to headset on an active call
● ●
Press On/Quiet. Hang up the handset.
Headset to handset on an active call
●
Lift handset.
** To answer calls manually, you must first deactivate the Auto-Answer feature.
iss1, cib3130-5
