Preview only show first 10 pages with watermark. For full document please download

Cisco (tandberg) Management Server Installation Sheet

   EMBED

Share

Transcript

Management Server Installation IMPORTANT: THE USER MANUAL CD FOR THIS PRODUCT CONTAINS IMPORTANT TERMS AND CONDITIONS INCLUDING END USER LICENSE AGREEMENTS. THE LICENSE AGREEMENTS SHOULD BE READ PRIOR TO USE. USE OF THIS PRODUCT CONSTITUTES ACCEPTANCE OF THE TERMS OF THE LICENSES. 115807 rev. 1 TURN OVER FOR INSTALLATION INSTRUCTIONS Management Server Installation 1 2 3 LAN1 LAN3 LAN4 N1 LAN4 LA LAN4 LAN3 LAN3 LAN2 LAN2 LAN2 LAN1 LAN1 N2 N1 LA LA N4 N4 LA LAN4 LA LAN3 N3 LA LAN2 N3 N2 LA LA LAN1 LAN4 LAN3 LAN4 LAN3 LAN2 LAN2 LAN1 5 LAN1 LAN4 4 Mount the rack ears and/or rubber feet, if applicable, and turn the unit back on its feet or mount it in the rack. Turn the unit upside down. Unpack the Management Server. LAN3 LAN3 LAN2 LAN2 LAN1 LAN1 6 I o LAN4 I o LAN1 Connect the Ethernet LAN cable to socket LAN 1. 7 Connect the power cable and turn on the Management Server. IP Setting Configuration 1. Press Enter. 2. From the Main Menu screen, use the Up or Down arrow to select IP Settings. Press Enter to confirm your selection. 3. From the IP Settings menu, use the Up or Down arrow to select IP Address and press Enter twice to start the edit mode. 4. Move between the characters by using the Up or Down arrows. Press Enter and then Up or Down to edit the characters, and Enter again to confirm the value, or Return to restore the value to its previous state. 5. When finished editing the address, press Return. At the Save Changes? prompt, use the Up or Down arrow to select Yes and press Enter to confirm. 6. Repeat steps 3–5 to enter Subnet Mask and Default Gateway addresses. 8 LAN2 LAN3 LAN4 Configure IP Settings via the LCD panel. Management Server configuration 1. Access the TANDBERG Management Server by entering the IP address of the server in a web browser. 2. When prompted for login, enter the username administrator and password TANDBERG. The password is case-sensitive. 3. To configure the Management Server, go to Administrative Tools. For details, see the TANDBERG Management Server manual on the enclosed CD. 4. Once the initial setup has been completed, log in to https://:8098/ and use the Set Administrative Password tool to change the administrator password. 115807 rev. 1