Preview only show first 10 pages with watermark. For full document please download

Clamp Lamp 148mml X 210mmd Cpin002897 Note:

   EMBED

Share

Transcript

148mmL x 210mmD CPIN002897 clamp LAMP ATL538 NOTE: SPECIFICATION LED MODULE IS NON-REPLACEABLE. Lamp 22 x 0.23watt LED 5watt total Adapter output 6Vdc 1000mA To adjust the lamp head To adjust lamp height, simply bend lamp neck to your desired height as shown in figure.1. Minimum distance of 0.2m must be maintained between the lamp head and any illuminated object. 0.2m TO USE YOUR LAMP Use only the power adapter supplied. Attach the lamp using the clip base to a stable surface such as a table top or workbench. Plug lamp into the power adapter supplied. Plug the adapter into 240volt mains socket and switch power on. To operate the lamp, switch on and off using the switch located on the lamp cord. INSTRUCTIONS FOR USE & CARE 1. Use the lamp indoors only. 2. Keep out of reach of young children and pets. 3. To clean the lamp, use a clean dry cloth. Wait 10 minutes after disconnecting to allow time to cool. 4. The lamp head and the power adapter will run quite warm to touch – this is normal. 5. If not using the lamp for long periods, switch the power adapter off at the mains socket. 6. The LED lamp is non-replaceable 7. The electrical parts can only be serviced by a qualified tradesman, in compliance with standards/specifications. CPIN002897 Flexible goose neck to adjust lamp head in to position. figure 1. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE FIRST USE. aren