Preview only show first 10 pages with watermark. For full document please download

Classic Bottom Lever Mounting Flushmount Handle

   EMBED

Share

Transcript

NEW CONSTRUCTION WINDOWS Step 1) Install the mortise lock with the hook facing up as shown. It is secured in place by the two (ea.) #6-32 truss head screws provided. Classic Bottom Lever Mounting Flushmount Handle Instructions. (KEYLOCK HSG) 5/16” DIA HOLES TO ACCOMMODATE BOSSES ON ESCUTCHEON (KEY CYLINDER) Step 2) Insert the handle lever into the hub of the mortise lock from the interior side. Step 3) Place the interior and exterior handles on the door and secure in place with the #8-#32 machine screws provided. CAUTION! HAND TIGHTEN ONLY. USE OF SCREW GUN MAY CAUSE DAMAGE TO THE HANDLE. (HANDLE LEVER) Step 4) (INTERIOR HANDLE) (KEY CYL MTG SCREW) 3.937 SHOWN UNASSEMBLED FOR DESCRIPTION PURPOSES ONLY. HANDLE, CYLINDER AND KEY LOCK BLOCK WILL BE PRE-ASSEMBLED. Using the lock hook as a location guide, install two of the supplied pan head screws through the SLOTS in the strike to attach the strike on the door jamb. Do not fully tighten these screws to allow the strike to be vertically adjusted (Figure A). Step 5) Adjust the door rollers for proper operation. (HOOK ADJUSTMENT SCREW) (MORTISE LOCK) (HUB) (2ea) (#8-32 MACHINE SCREW) (#6-32 X 1/2”) (2ea) #8-32 X 1-7/8” OVHD M.S. INS2998-06 - New Construction Vinyl Classic VPD Handle Instructions_July 2015 Step 6) Figure A Adjust the strike vertically to engage the lock hook and tighten the first two screws. Step 7) Install the remaining two pan head screws through the HOLES in the strike (Figure B). Step 8) After the door and striker are aligned, the in and out hook adjustment may be made by turning the screw on the top face of the mortise lock. Figure B