Transcript
StarServe Infrared Target, 5V Installation Instructions 8050TR
Home Management Series
StarServe Infrared Target Installation Instructions
1.0 Product Range 8050TR StarServe Infrared Target, 5V 2.0 Description The 8050TR Infrared Target contains an infrared receiver array, designed to receive and relay IR data from remote locations to a centrally located 8053/8VHPIR StarServe Video Hub. An 8050TR Infrared Target may be installed at each TV location, allowing user control of audio/visual equipment (such as VCRs, Cable TV Decoders, CD Players etc) from each remote location. Infrared signals in any StarServe system are broadcast across the same RG6 coaxial cable as used to carry the RF video signals. Significant savings can be realized by not having to run dedicated cabling to support these IR services. The 8050TR StarServe Infrared Target incorporates two F-Type connections, and is designed as an in-line device. Terminations are clearly marked on the rear of the unit. Terminal Marking
Connection
Recommended Cable Type
Connects to:
FROM SYS
F-Type
RG6 Coaxial
TO TV
F-Type
RG6 Coaxial
8053/8VHPIR StarServe Video Hub Remote TV
Copyright Notice 2001 Copyright Clipsal Integrated Systems Pty Ltd. All rights reserved. Trademarks • Clipsal is a registered trademark of Gerard Industries Pty Ltd. • StarServe is a registered trademark of Clipsal Integrated Systems Pty Ltd • Home Management Series is a registered trademark of Clipsal Integrated Systems Pty Ltd All other logos and trademarks are the property of their respective owners. Disclaimer Clipsal Integrated Systems reserves the right to change specifications or designs described in this manual without notice and without obligation. Copyright 2001
Clipsal Integrated Systems Pty Ltd
Page 2 of 4
Home Management Series
StarServe Infrared Target Installation Instructions
The diagram below shows a typical StarServe installation featuring IR control from a remote location.
Figure 1. StarServe IR Repeating System – Example using StarServe 8052VMPIR Modulator
Figure 2. StarServe IR Repeating System – Example using StarServe 2031RFT IR/RF Controller Copyright 2001
Clipsal Integrated Systems Pty Ltd
Page 3 of 4
Home Management Series
StarServe Infrared Target Installation Instructions
3.0 Product Specifications Catalogue No. Input Voltage Connection Mechanical Details
8050TR
Nominal 5VDC Maximum 12VDC Line In 1 x F-Type Connector Line Out 1 x F-Type Connector Colour Black Dimensions 87 x 23 x 60mm (LxWxD) Shipping Weight 0.2kg Operating Temperature 0 – 50°C Operating Humidity 10 – 95% RH Specifications typical @ 25ºC ± 5ºC No user serviceable parts inside.
Further Information For further information about Clipsal StarServe, please consult the documentation supplied. Further assistance can be obtained as follows: • StarServe Installers Guide A printed booklet containing detailed information for the installer regarding StarServe system design. • Technical Support and Troubleshooting For further assistance in using Clipsal StarServe, please consult your nearest Clipsal Integrated Systems Sales Representative or Technical Support Officer. Technical Support Hotline Technical Support Email Sales Support Email Clipsal Integrated Systems Website
1300 722 247 (Cost 25c per Call)
[email protected] [email protected] clipsal.com/cis
Products of Clipsal Integrated Systems Pty Ltd ACN 089 444 931 ABN 15 089 444 931 Head Office 12 Park Terrace, Bowden South Australia 5007 International Phone +61 8 8269 0560 International Fax +61 8 8346 0845 Internet clipsal.com/cis E-Mail
[email protected]
1036875
