Preview only show first 10 pages with watermark. For full document please download

Cn2 Serial Adapter Instructions

   EMBED

Share

Transcript

CN2 Serial Adapter Instructions Use the CN2 Serial Adapter (P/N 074247) to turn the 16-pin serial port (COM1) on the CN2 into a DB9 (9-pin) male serial connector that you can connect to a serial printer or a button link. Installing and Using the Serial Adapter 1 Remove the serial port plug from the serial port. Serial port plug Clips DB9 connector 2 Slide the serial adapter onto the CN2 and snap the two clips into place on the CN2. 3 Connect a serial printer or button link to the DB9 connector on the serial adapter. Removing the Serial Adapter 1 While holding the CN2, push down on the serial adapter until the clips are released from the CN2. Clips 2 Slide the adapter off the CN2. DB9 Connector Pin Assignments 1 - Not connected Data set ready (DSR) - 6 Button link power - 7 Clear to send (CTS) - 8 Not connected - 9 2 - Receive data (RXD) 3 - Transmit data (TXD) 4 - Button link power 5 - Ground Pin Assignments: This illustration shows the pin assignments for the DB9 male connector on the serial adapter. Pins 4 and 7 supply power to the button link. Pin 9 does not supply power to external devices. Specifications Electrical rating: x 7.4 V, 20 mA peak Communications port: DB9 male connector, RS-232 without RI, CD, DTR, and RTS Operating temperature: 0°C to 50°C (32°F to 122°F) Storage temperature: -10°C to 50°C (14°F to 122°F) Relative humidity: 5% to 95%, non-condensing Serial port settings: Baud Rate 115200 Data Bits 8 Parity N Stop Bit 1 Flow Control None Use an application to change these settings. 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2005 Intermec Technologies Corporation. All rights reserved. CN2 Serial Adapter Instructions *074758-002* P/N 074758-002