Preview only show first 10 pages with watermark. For full document please download

Coiled Power Cord (9a493 W/ Three Outlets)

   EMBED

Share

Transcript

62XX-501-40 9A493001 Installation Instructions INS-9A493001 (Rev.A) Tools required: #2 Phillips Drive Screw driver or #2 Square bit drive 1 Arrange Power Cord Set within Cord Tray (See Fig.A) 2 Fasten Power Cord Set from underneath the worksurface by placing cord in cord clamp and fasten with 1/4-20 x 5/8” Long Pan Head Phillips Drive Machine Screw. Parts Included: (1) Power Cord Set (1) Cord Hook Bracket (2) #10 x 3/4” Long Pan Head Phillips Drive Recex Low Root Screws (1) 1/4-20 x 5/8” Long Pan Head Phillips Drive Machine Screws (1) Cord Clamp Note: Make sure that the cord clamp is fastened to the right of where Cord set is shrink tubed.(See Fig.B for diagram of Power Cord Set) 3 Fig. E From underneath the worksurface, align cord tray with pre-drilled holes in worksurface. Fig. A Once aligned, fasten (4) #10 x 3/4” Long Pan Head Phillips Drive screws into the front (4) four locations (See Fig. C). Finish attachment by placing and attaching last two (2) #10-24 x 7/8” Long Pan Head Phillips Drive Screws into the back side of cord tray (See Fig. D) 4 Attach Cord Hook from underneath the worksurface using (2) #10 x 3/4” Long Pan Head Phillips Drive Recex Low Root Screws (See Fig.E) Fig. C Fig. D Fig. B Power Cord Set Cord Clamp Shrink Tube Midmark Corporation | 60 Vista Drive | PO Box 286 | Versailles, Ohio 45380-0286 | USA | midmark.com