Transcript
ETC ® Installation Guide ColorSource ® ThruPower Locking Door Kit Overview The ColorSource ThruPower Locking Door prevents tampering or damage to both the breakers and the user interface.
Installation Parts and Specialty Tools Required • Phillips screwdriver
Kit Part Number • 7121K1000
Included in the kit • • • •
Three M3.5 * 14mm Screws, four M4 * 10mm screws Safety Cover Locking Door 2 Keys
Door Guard
Hinge
Screws for the Hinge
Locking door Key
Install Locking Door Step 1:
Thread three M3.5 screws through the door guard and into the appropriate holes in the front of the unit. Make sure the door guard is installed as shown on the image above.
Step 2:
Align the screw holes of the hinge to the holes in the rack and using the four provided M4 screws, install the locking door.
Step 3:
Verify operation of the locking door.
Corporate Headquarters Middleton, WI, USA Tel +608 831 4116 Service: (Americas)
[email protected] London, UK Tel +44 (0)20 8896 1000 Service: (UK)
[email protected] Rome, IT Tel +39 (06) 32 111 683 Service: (UK)
[email protected] Holzkirchen, DE Tel +49 (80 24) 47 00-0 Service: (DE)
[email protected] Hong Kong Tel +852 2799 1220 Service: (Asia)
[email protected] Web: www.etcconnect.com © 2016 ETC. All Rights Reserved. Product information and specifications subject to change. 7121M2110 Rev A Released 2016-03 ETC intends this document to be provided in its entirety.
Locking Door Kit Install Guide
Page 1 of 1
Electronic Theatre Controls, Inc.