Transcript
Components List Cammegh Double-Sided Billboard with EyeCard The components listed on this page are required to assemble 1 Cammegh Double-Sided Billboard with EyeCard. This does not necessarily represent the total contents of your order. Components are not shown to scale. For more help or further information, visit www.cammegh.com or call the Cammegh office on +44 (0)1233 820771.
1 x Billboard Controller
2 x Display Power Adaptors
2 x Displays
3 x Kettle Leads
1 x Display Stand
CAMMEGH
1 x HDMI Splitter
1 x Billboard Power Adaptor
4 x Top Plate Bolts
4 x EyeCard Bracket Bolts
1 x EyeCard Mounting Bracket
8 x Screen Bolts
1 x EyeCard Camera
1 x Mini-B USB Cable
1 x USB Keypad/Number Keypad
1 x Clamp Ring
1 x Table Bracket (optional)
1 x Top Plate
Mounting Screws
You will also need:
Medium flat head screwdriver
Electric drill with cross-head bit
5mm Allen key
3mm Allen key
2.5mm Allen key
ø 50mm Holesaw
1 x Clamp Ring Spanner
1) Thread the lead from the mini-B USB cable through the top plate.
2) Push the lead from the mini-B USB cable into the groove on the back of one of the displays to protect it.
3) Place the two displays back-to-back.
4) Attach the screen top plate to the top of both displays using four top plate bolts in either the front or back four of the eight holes available.
5) Thread the five cables from the displays and mini-B USB cable through the display stand, from plate end to ring.
6) Attach the EyeCard mounting bracket to the top of the display using the EyeCard bracket bolts provided.
7) Screw the EyeCard camera onto the top thread of the EyeCard mounting bracket and plug in the mini-B USB cable.
9) If your order does NOT include table brackets, drill a hole with diameter 50mm through the table in which to mount the display stand Allow a gap of at least 70mm between the centre of the hole and all other objects to allow space for the bracing ring on the stand pole.
11) Thread all cables through the stand clamp ring, ensuring the side with the chamfered hole edges faces down.
8) Attach the stand pole to the displays by screwing eight screen bolts through the holes in the stand top plate (double-sided).
10) Thread all cables through the table hole and insert the display stand’s long thread so the bracing ring sits flat against the table top.
12) Screw the stand clamp ring onto the long thread of the display stand until it is flat against the table. Tighten firmly using the clamp ring spanner and secure with screws if desired.
13) Detatch the mounting plate from the bottom of the billboard controller and screw it to the underside of the table. Ensure that the plate is within reach of all cables and has adequate space around it for ventilation.
14) Secure the billboard controller to the mounting plate by inserting the plate’s protrusions into the billboard controller’s holes and screwing in the spring-loaded clamping thread until tight.
15) Plug the HDMI splitter cable into the HDMI port. Plug the keypad into any available USB port. Attach a kettle lead to the billboard power adaptor and plug the adaptor’s cable into the hexagonal power socket.
16) Attach the HDMI plugs from both displays to the double end of the HDMI splitter cable. Plug the mini-B USB cable (attached to the EyeCard camera) into one of the two blue USB ports.
17) Plug a kettle lead into both of the display power adaptors, and connect the displays’ power cables to those of the adaptors.
18) Switch on the displays and adjust the colour of their LED strips by inserting a flat head screwdriver into the small hole on the bottom of each display case and turning the screw.
