Transcript
EN Ee PET CLIPPER CP-7010 INSTRUCTIONS Congratualtions EE on purchasing the high quality Pet Clipper CP-7010. Caution: Read the instructions carefully before using the product! Safety instructions: To avoid injury or electric shock, the following precautions should be strictly observed: -
-
Turn the device off by turning the switch (A) to “0” and removing the plug from the socket. Connect the device to the power using the provided AC-adapter and turn the power on. Please pay attention to the power rating. Never leave switched on electrical appliances unattended. After use turn the clipper off and remove the power plug from the socket. Do not immerse the appliance or power cord in water or other liquids. If the appliance does come into contact with water, immediately remove the power plug and have the unit checked by a professional before using it. Use this appliance only for its intended use as described in this manual. Do not attempt to change or remove any of the moving parts. Do not use extra attachments or accessories that are not recommended in this manual. Do not use a device with a damaged cable or plug. Keep the power cable away from hot surfaces. If the clipper is not working properly, or has been dropped or damaged, do not use it any further and have the unit checked by a professional. Never drop or insert any object into any opening of the appliance. Before use, ensure that the cutting head and clipper blades are not damaged, as this can lead to damage of your pet’s skin or hair. Caution: do not use or store this product in a place where it can be damaged by pets or weather conditions. Please dispose of this product at an officially authorized location when it no longer serves its purpose.
Technical information: -
220-240 Volt, 50 Hz AC Wattage: 15 Watt Powerful motor: quiet, easy maintenance, no overheating, long-lasting The device is EWG Radio interference suppressed in accordance with EU regulation no. 87/308. Cutting length: the normal cutting length of the clipper without comb attachment is approx. 1mm. Using the adjustment lever (B) on the side of the clipper the cutting length can be adjusted from 0.45mm to 0.8mm. Use the lock (C) to fix the setting. The clipper also includes 4 comb attachments which allow you to vary the cutting length. The combs can change the cutting length to approx. 3mm, 6mm, 9mm and 12mm. The comb attachment (D) is attached to the clipper by pushing it over the front edge of the clipper until it clicks into place. Caution: The clipper motor is pre-oiled by the manufacturer. Further maintenance is unnecessary and should only be carried out by a professional.
Care instructions for the Pet Clipper CP-7010: -
-
For cleaning and maintenance, or for changing the clipper blades, turn off the machine and remove from the power source. Always unplug before cleaning. Never submerge the device in water. Remove all attachments before each use, and use the cleaning brush to remove hairs from the cutting blade and surrounding area. Clean the housing of the machine with a soft, damp cloth. Never use alcohol or abrasive cleaners! The cutting head (E) should be regularly oiled (every 3-4 minutes during use), in order to keep the blades sharp and accurate, and to maintain the long life of the product. Please note: oil sprays are not suitable for this! If the cutting comb and blades become dull or blunt after long term use, despite good cleaning and oiling, these should be replaced (F). In order to do so, unplug the machine from the power source, then remove both screws on the plate of the cutting comb, and remove the cutting comb and blade. When reassembling, place the cutting blade with the guiding slit on the v-shaped plastic guide, and press it down, so that the peg slots into the cut-out in the blade. Next, replace the cutting comb plate and reinsert the screws. Before tightening, align the cutting comb plate so that there is a distance of 0.5 mm between the front edge of the cutting comb and the razor (Fig. G) when the minimum cut length is set. Also pay attention to this distance when removing and repositioning the blade for cleaning.
F
D
E
G
