Preview only show first 10 pages with watermark. For full document please download

Control Panel Replacement

   EMBED

Share

Transcript

ut o ck o ly vide e h b C ilt sem sterbu l! s a a our the M hanne on ube C t You Control Panel Replacement Instruction for Generation II Electric Smokers Part No. 9007120007 and 9007120015 BE A PART OF OUR “DADGUM GOOD” COMMUNITY ONLINE: www.masterbuilt.com | www.dadgumthatsgood.com | www.facebook.com/masterbuilt Twitter @Masterbuilt @JohnMcLemore @DadgumThatsGood Required Tool: Short Phillips Head Screwdriver 9807140021 032114-23GH PARTS AND HARDWARE Part No. Qty. Description 1 1 Control Panel 1 CAUTION Masterbuilt Manufacturing, Inc. 1 Masterbuilt Court Columbus, Georgia 31907 Customer Service 1-800-489-1581 • ALWAYS REMOVE PLUG FROM OUTLET BEFORE SERVICING! • MAKE SURE UNIT HAS FULLY COOLED TO AVOID BURNING! • EDGES MAY BE SHARP. USE CAUTION TO AVOID INJURY! 021513-23JH Disconnect unit from power source, and allow it to fully cool, before replacing control panel. Step 1: Remove screw on left side of smoker body as shown below. Step 2: Remove screw on right side of smoker body. Step 5: Disconnect wires connecting control panel housing to smoker body. Step 6: Remove screws as shown below to remove control panel from housing. Note : Do not disconnect red and black wiring. Step 7: Insert new control panel into control panel housing. Step 3: Remove 4 screws from the control panel housing as shown. Note : Some parts not shown for clarity. Step 4: Pull control panel housing out and up to remove. Step 8: Follow Steps 1-6 in reverse order, to connect new control panel. Step 9: Connect unit to power source, to ensure new control panel is properly connected.* After testing allow unit to fully cool. * If your smoker model has a remote control, it will need to be linked with the new control panel before it will function properly. See below for directions. How to Link Remote Control: A. Turn control panel and remote control “OFF”. B. Press and hold “SET TEMP” on control panel for 3 seconds. C. On the remote control press, “MEAT PROBE”, “LIGHT”, “MEAT PROBE”, “LIGHT” (all buttons must be pressed within 5 seconds of each other) A short beep will occur after each button press. 1 2