Transcript
2 in 1 CONVECTOR PANEL HEATER Floor and Wall-mounted
Model: HFCP1000 / HFCP1500 / HFCP2000
Instruction Booklet: Please read these instructions carefully and retain for future reference
Contents Safety Instructions Specifications Assembly for floor Wall installation Operation Cleaning Heater
Safety Precautions for your heater READ ALL INSTRUCTIONS BEFORE USING THIS HEATER WARNING-DANGER OF BURNS SAFETY PRECAUTIONS FOR YOUR HEATER. •To provide continued protection against risk of electric shock, connect to properly grounded outlets only. •To avoid fire or shock hazard, plug the appliance directly into a 240V AC electrical outlet. •Do not use outdoors. • Your heater is intended for domestic household use only. • Always unplug the heater from the power outlet when not in use. • This heater becomes hot during use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (90cm) away from the front of the heater and keep them away from the sides and rear. • Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left unattended. • Always unplug the heater when not in use. • Do not use outdoors. • Do not run the cord of the heater under carpeting. Do not cover the cord with throw rugs, runners or other floor coverings. Arrange the cord away from traffic areas where it will not be tripped over. • Do not locate the heater immediately below a socket outlet. • Do not use this heater in the immediate surrounds of a bath, shower, laundry area or swimming pool. • Do not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause electric shock or fire, or damage to the heater. • To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, such as beds, where opening may become blocked. • A heater has hot and arcing or sparing parts inside. Do not use it in areas where petrol, paint or flammable liquids are used or stored. • The heater must not be located immediately below a socket-outlet. •Allow the heater to cool completely before servicing. •This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of this appliance by a person responsible for their safety. • DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable
parts. All servicing should be performed by qualified personnel only.
Additional Precautions • Read carefully and save all the instructions provided with heater. • Always turn the power off at the power outlet before you insert or remove a plug. Remove by grasping the plug - do not pull on the cord. • Turn the power off and remove the plug when the heater is not in use. • Do not use your heater with an extension cord. • Always use your heater from a power outlet of the voltage (A.C. only). • Close supervision is necessary when your heater is being used near children or infirm persons. • Young children should be supervised to ensure that they do not play with the heater. • Never leave the heater unattended while in use. • Do not use the heater for any purpose other than its intended use. • Do not place the heater on or near a hot gas flame, electric element or on a heated oven. Do not place on top of any other appliance. • Do not let the power cord of the heater hang over the edge of a table or bench top or touch any hot surface. • Do not operate any electrical appliance with a damaged cord or after the appliance has been damaged in any manner. If damage is suspected, return the heater to the nearest service centre for repair. • Do not immerse the heater in water or any other liquid. • Use only as described in this manual. Use only manufacturer’s recommended accessories. • This heater draws 8.7 amps during operation. To prevent overloading a circuit, do not plug the heater into a circuit that is already being used to power other appliances. • While it is normal for the heater’s plug to feel warm to the touch, a loose fit between the plug and the electrical outlet may cause overheating and warping of the plug. If the outlet is loose, contact a qualified electrician to replace loose or worn outlets.
This heater is equipped with a grounded type plug and must be plugged into a grounded type outlet. This is a safety feature: DO NOT REPLACE THIS PLUG!
WARNING – In order to avoid overheating, do not cover the heater – Do not use this heater with a programmer, timer, separate remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
Specifications Model
HFCP1000
Power
900-1000W
Voltage:
220V-240V,AC
HFCP1500
HFCP2000
1350-1500W
1800-2000W
/ 50Hz
Assembly for floor Before using the heater as a floor type, attach the feet to the unit. Attach feet to the base of the heater using the 4 tapping screws provided, taking care to ensure that they are located correctly in the bottom ends of the heater.(Fig.1)
Fig.1
Wall Mounting Instructions WARNING: Heater should be located on the wall where no combustible material is above the heater, and other sides of the heater should be at least 3 feet (0.9m) away from the nearby combustible materials. 1. For wall mounting, enough space must be left around the heater. (Fig.2)
Fig.2
Fig.3 2. Draw two horizontal lines on the wall, 255mm distance between the two lines. 3. Drill two holes at the end of each horizontal line, drill four holes for the plastic inserts (included). Distance for the two holes for upper horizontal line should be L1, the same as that of the slots on the back of the heater. The distance for the two holes for the lower line should be L2. (Fig.3) 4. Insert the plastic inserts into the four holes on the wall. (Fig.4)
Fig.4 5. Insert two screws to the upper plastic inserts, leave the head of the screws protruding 8mm. (Fig. 4) 6. Install two spacers in the bottom of the heater. (Fig 5)
Fig.5 7. Slip the two hooks over the screw head and slide into the slot, then tighten screws to the hooks. (Fig. 6)
Fig.6
8. Hang up the heater on the wall by aligning the slots onto the hooks. 9. Insert screws thru holes in spacers at bottom of the heater and fasten to the wall. (Fig.7)
Fig. 7
Operation NOTE: When you first turn on your heater it may emit a slight odor, this is normal. This odor will dissipate after the heater has been on a short time. Plug the unit to electrical outlet.
ON/OFF Switch Turn power switch to “ON”. The ON/OFF switch controls the heater’s operation.
Thermostat Dial The thermostat dial allows you to set your desired temperature level. The thermostat monitors the room’s temperature and continuously adjusts the heat output to maintain your selected comfort level. The element is only powered for as long as necessary to restore the selected temperature, ensuring maximum efficiency. Turn CW to raise temperature, CCW to lower temperature. Turn the switch/thermostat clockwise to the desired position.
In its minimum setting (fully counter-clockwise) position, in this position (depending on the size of the room) the heater will maintain the temperature above freezing. This appliance must be earthed. Use only the proper type outlet when plugging in the appliance; do not attempt to override the earth wire feature.
Setting the Timer To use the heater in timed mode, it should be permanently connected to the mains supply. If the power is disconnected, the clock will stop. To operate the heater in timed mode, the three position switch within the dial should be in the center position, If it is in the “-” position, the heater will be permanently ON, if it is in the “O” position, the heater will be permanently OFF. The timer is in 24-hour format. The timer is controlled by the plastic segments-each segment represents 15 minutes. Pull the segment out to turn the heater “ON” for that period of time, push in for “OFF”.
Setting the Time The current day and time is set by rotating the timer dial clockwise until the correct day and time is indicated opposite the datum mark.
Cleaning the Heater Always un-plug the heater from the outlet and allow it to cool down before cleaning. Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth. Do not use any detergents or abrasives and do not allow any water to enter the heater. If the heater is not going to be used for long periods of time, it should be unplugged and protected from dust and stored in a clean dry place.
Declaration of Conformity We ACL Group (Intl.) Ltd, England DN6 8LZ declare that the Homefront Panel Heater has been manufactured according to our full quality assurance procedures. The declaration is to certify that it conforms to CE, EMC, LVD and RoHS directives: EN55014-1:2006 EN61000-3-2:2006 EN61000-3-3:2008 EN55014-2:1997 +A1:2001 +A2:2008 All provisions of Annex 1 of Council Directive 2004/108/EC – EMC directive EN60335-2-2:2003 +A1:2004 +A2:2006 EN60335-1:2002 +A11:2004 + A1:2004 + A12:2006 + A2:2006 + A13:2008
EN62233:2008 All provisions of Annex 1 of Council Directive 2006/95/EC – Low Voltage Directive RoHs 2002/95/EC
Mr Alan Garnett, UK QA Manager
Environmental Protection RECYCLING: WASTE ELECTRICAL PRODUCTS SHOULD NOT BE DISPOSED OF WITH HOUSEHOLD WASTE. PLEASE RECYCLE WHERE FACILITIES EXIST. CHECK WITH YOUR LOCAL AUTHORITY OR RETAILER FOR RECYCLING ADVICE.
12 Months Limited Warranty Here at ACL we are confident that you will be pleased with your purchase of the Homefront Panel Heater. However if within 12 months from the date of purchase you experience any problems due to defects in materials or manufacture, please contact us directly on 0844 8000031 for technical advice. Should your product develop a fault, please follow these steps immediately: • Call our technical helpline on 0844 8000031 for technical advice. Or for exchange or refund please contact your place of purchase. • This does not affect your statutory rights.
