Preview only show first 10 pages with watermark. For full document please download

Cpu Holder Install Instruction.cdr

   EMBED

Share

Transcript

CPU Holder Installation Model A & B Content: Qty 1: CPU Holder. Qty 1: 4 mounting screws. Qty 1: Allen Wrench. With Swivel Mount With Swivel/Slide Mount Other tools needed/helpfull but not included: - Electric drill with Philips bit and/or Philips head screw driver. - Small drill bit for pre-drilling. Drill size 2 mm or 5/64 inch. - Tape measure (helpful but not required). *Note: Included screws are suitable for wood/wood-based table tops. May not be suitable for all table top surfaces, including hollow tops, certain plastic materials, and metal tops. Installer must ensure that mounting hardware is suitable for the material. Step 1: Loosen set screws which secures lower bracket to the upper bracket (fig 1, #1). Step 2: Use upper bracket for marking hole pattern and pre-drill screw holes under table top. Pre-drilling is recommended but not required. Step 3: Mount upper bracket, using the included screws (fig 1, #2)* Step 4: Measure height of CPU Holder. Add 5mm (1/4 inch) to CPU height for clearance height. Step 5: Install lower bracket, by sliding up into upper bracket. Secure at correct clearance height from step 4. Secure by tightening set screws tightly. (fig 1, #1). Step 6: Place CPU in CPU holder and slide in locking bracket until pressed against CPU (fig 2, #3). Secure by pushing locking handle tightly in place (fig 2, #3). CPU holder parts Fig. 1 Fig. 2 Upper bracket Table top Locking handle 2 Locking bracket Set screws 4 3 1 Lower bracket Optional parts (not included): Spacer (For crossbars) www.space.dk Swivel mount Slide & Swivel mount