Transcript
CRS-S1040-SAS 4x 2.5” HDD/SSD in 5.25” Backplane Module
User manual Features: z z z z z z z z z z z z
Material: Interface: Form Factor: Drive bays: Transfer rate: Connectors: Cooling: Indicators: Color: Hot-swap: Dimensions: Weight:
Aluminum housing, metal trays, plastic front bezels SAS & SATA 1 x 5.25” 4x 2.5” HDD/SSD bay, max. drive height = 14.5mm Up to 3Gb/s per drive 1x 4-pin power, 8x 7-pin data 2x 40x40x20mm fan Drive power and activity LED’s Black Supported (must be supported by the SAS/SATA controller as well) 146(W) x 42(H) x 175(D) mm 0.79KG
1. Removing and inserting the tray:
A1. unlocking the tray 1 2
A2. locking the tray
Remove the tray by pushing the blue lever to the left and pull it out (picture A1). Insert the tray by sliding it in until it stops and then push the lever to slide the tray completely in and to lock the tray.
2. HDD Installation:
B1. tray with a 10.5mm thick drive
1 2
B2. tray with a 14.5mm thick drive
A 2.5” drive with a maximum height of 10.5mm (picture B1) can be inserted into the tray from the side and fixed with the screws provided. For a 2.5” drive with a height of 10.5 to 14.5mm (picture B2) the cover of the tray has to be removed first by removing the screw on top. The drive can then be inserted and fixed with the screws provided. Do NOT replace the tray cover!
3. Connections and functions:
C1. Front view
Item:
Description:
1~4
Drive trays
5
Locking lever
6
Power and activity LED
C2. Rear view
***
Item:
Description:
7
4-pin power connector
8+9
40mm cooling fan
10~13
Primary data channels (for SATA and SAS drives)
14~17
Secondary data channels (for SAS drives only)
18
Activity LED function switch***
When the activity LED switch is set to “O” the drive activity signal from the drives is shown on the blue LED’s (blinking), this function is disabled when the switch is set to “X”.
