Transcript
CSD-SMA-2500 Surge Diverter SMA Coaxial Cable Power Surge Protection Specifications Parameters Frequency
< 2.5GHz
Insertion Loss
<0.2dB
Max RF Power
37W
Clamping Voltage
90Vdc
VSWR
1.20:1
Impedance
50Ohms
Max Discharge Current
40kA (8/20us)
Connectors
SMA Male - SMA Female General
Description
Size
41mm x 22mm (1.6” x 0.9”)
The CSD-SMA-2500 Surge Diverter is a low insertion loss for applications up to 2.5GHz. This in-line surge arrestor has SMA male and SMA female connectors and fitted 6mm2 earth cable, that protects the module from the impact of lightning/transients via the antenna port.
Housing
Plated Brass
Mounting
In-line between ELPRO product and coaxial cable
Weight
100g (3.5oz)
The CSD-SMA-2500 is designed to be connected directly to the antenna port allowing simple installation or retrofit. Used with the CC3, CC10, CC20 SMA male to N-type male coaxial cable kits, allows connection to ELPRO products with SMA female/male antenna connector. Note: Surge Protection Devices rely on good earthing practices to be effective. This product assumes both a metallic enclosure and good earth connection to the enclosure. If in doubt, apply another earth under the locknut to create a sufficient Earth. Also note: In applications of high vibration, it is recommended to use CSD-N-6000 Surge Diverter. Warning: Do not stand near or touch operating equipment during an electrical storm as the CSD-SMA-2500 will not protect personnel.
Note: Specifications subject to change.
Ordering To order, select product code from the table and specify country of application. Product Code
Description
CSD-SMA-2500
SMA Surge Diverter for use with CC3, CC10, CC20-SMA
Product Compatibility The following products are compatible with this accessory. Please refer to product datasheets for compatibility details to suit your application. Product Code
Description
Data Sheet #
CC3-SMA CC10-SMA CC20-SMA
Coaxial Cable Kit - 3m (9.8’)/10m (32’)/20m (65’), N-type to SMA
7932 7947 7948
CCTAIL-SMA-F
Coaxial Cable Tail - 600mm (24”), N-type Female to BNC/SMA Male
7951
The only controlled copy of this Data Sheet is the electronic read-only version located on the Cooper Bussmann Network Drive. All other copies of this document are by definition uncontrolled. This bulletin is intended to clearly present comprehensive product data and provide technical information that will help the end user with design applications. Cooper Bussmann reserves the right, without notice, to change design or construction of any products and to discontinue or limit distribution of any products. Cooper Bussmann also reserves the right to change or update, without notice, any technical information contained in this bulletin. Once a product has been selected, it should be tested by the user in all possible applications.
©2013 Cooper Bussmann www.cooperbussmann.com/wireless 0513
BU-SB13583
Page 1 of 1
Datasheet: 7959
