Transcript
DATA SHEET
CROSS TECHNOLOGIES, INC.
REV. B
4/16/14
4115-41-212 Ka-band Block Upconverter, Weather Resistant The 4115-41-212 Ka-band Block Upconverter converts 0.95 - 1.95 GHz up to 17.7 - 21.2 GHz in four selectable fixed bands. Front panel LEDs provide indication of DC Power and PLL Alarms. The L-band to RF gain is +30 dB. Connectors are 2.92.mm for RF Out and RF Monitor, SMA for the external reference input and reference output and Type N (all female) for the L-band. Gain, band select, and internal 10 MHz frequency are controlled by the Ethernet M&C. In AUTO, the 10 MHz reference stays in external if the external level is in the +2 to +8 dBm range. It is powered by a 100-240 ± 10% VAC power supply, and mounted in a 8”W X 6”H X 16”D Weather Resistant enclosure. STATUS / CONTROL
.. • • •..... .... .... ... • • • J6
ETHERNET
• •
J7
• •
J1
.
J2
FUSE F1
If an extended temperature range is required, there is an Extended Temperature option (Option W21; -30˚C to +60˚C) available at an additional cost. Contact Cross for quote.
ALARM
.
RF MON
*Weather Resistant enclosures are designed to be water resistant for installation in an outdoor enclosure/antenna hut OR mounted outdoors on an antenna assembly at their specified temperature ranges. They are designed to be located “out in the elements” (water, sleet, snow, etc.) but they are not designed to be “submerged under” water.
• •
.
MODEL 4115 UPCONVERTER
.
J8
POWER
CROSS TECHNOLOGIES INC.
RF OUTPUT
AC IN
.
10M IN
10M OUT
J3
J4
L-BAND IN
. J9
EQUIPMENT SPECIFICATIONS** Input Characteristics Impedance/Ret. Loss Frequency Noise Figure, Max. Input Level range Output Characteristics Impedance/Ret. Loss Frequency (GHz)
Output Level Range Output 1 dB comp. Mute
50Ω/14 dB 0.95 to 1.95 GHz 20 dB max gain -40 to -15 dBm
V A R
0.95 to 1.95 GHz IN
50 Ω /14 dB, Mute & UnMute BAND1 17.7 to 18.7 BAND2 18.3 to 19.3 BAND3 19.2 to 20.2 BAND4 20.2 to 21.2 -15 to 0 dBm +10 dBm, max gain >60 dB @ 0 dBm output
I S O L
12.7513.75 GHz
A T T
SW,PLL,ATT,VCC CONTROL
CONTROLLER
17.7 to 21.2 GHz BP
UPCON-513
1 - 11.20 2 - 11.80 3 - 11.00 4 - 11.80 GHz
5.5 to 8.0 GHz HP/LP
11.713.2 GHz
M&C
10 M TO PLLS
1-5.55 2-5.55 GHz
3-7.25 4-7.45 GHz
4115-41-212 Upconverter Block Diagram
2 0 dB C O U P
-20 RF MON 17.7 to 21.2 GHz OUT EXT 10 M
10 M MON
REV. A 5/23/13
Channel Characteristics Gain at Fc +30 ±3 dB, (+30 to 0 dB variable in 0.5 dB steps) Spurious, Inband SIG REL <-50 dBC in band, -15 to 0 dBm out; SIG IND, <-55 dBm; Over 17.7 to 21.2 GHz band Spurious, Out of band <-55 dBm; Over 17.0 to 22.0 GHz band Intermodulation <-50 dBC for two carriers at 4 MHz spacing, each at -5 dBm out Frequency Response ±2 dB, over RF band; ± 0.5 dB, 40 MHz BW Frequency Sense Non-inverting LO Characteristics LO Frequency Band Specific Frequency Accuracy ± 0.05 ppm max over temp internal reference; ext. ref. input 10 MHz level In/Mon +2 to +8 dBm in; Monitor Output = input level ± 1.0 dB, 50 ohms Phase Noise @ F (Hz) > dBC/Hz
100 -65
1K -75
10K -80
100K -95
1M -105
Controls, Indicators Gain, Band, 10M Freq. Gain, band select, and internal 10 MHz frequency via Ethernet M&C or Status/Control Connector PLL Alarm Red LED, External Contact Closure Power Green LED Other RF Out, RF Mon. Conn. 2.92mm (40GHz) female, 50Ω L-Band Connector Type N (female), 50Ω 10 MHz Connector SMA (female), 50Ω Status/Control Conn. Multipin MS3112E14-18S Weather Resistant Connector Size 8” Wide X 6“ High X 16” Deep Weather Resistant* Enclosure Power 100-240 ±10% VAC, 47 - 63 Hz, 25 watts max./ FCI Clipper Series CL1M1102 Weather Resistant Connector _________________________________________________________ *+0 to +50 degrees C; Specifications subject to change without notice
Cross Technologies, Inc.
•
6170 Shiloh Road • Alpharetta, GA 30005
www.crosstechnologies.com • 770.886.8005 • FAX 770.886.7964
