Transcript
1296 x 966
AD-131 GE
2 CCD High Dynamic Range camera
Two monochrome prism-mounted progressive scan CCDs (1/3”) Choice of high dynamic range, high frame rate, high S/N, or PIV mode 1296 (h) x 966 (v) active pixels per channel 3.75 µm square pixels 12-bit, 10-bit or 8-bit output – single or dual-channel 31 frames per second with full resolution Vairable partial scanning with user-definable height and starting line Programmable exposure from 11.49µs to 31.761ms GenICam Exposure Time Abs, pulse controlled, and auto shutter modes Sequence trigger mode for on-the-fly change of gain, exposure and ROI Built-in blemish compensation and shading compensation Look-up table (LUT) for gamma adjustment Separate AGC (automatic gain control) for each channel LVAL synchronous/asynchronous operation (auto-detect) Programmable GPIO with opto-isolated inputs and outputs Comprehensive control tool and SDK for Windows XP/Vista/7
31 FPS
GE
1/3” monochrome IT CCD (ICX447) 1/3” monochrome IT CCD (ICX447) 51.324 MHz 31 frames/sec.
Power Lens mount Dimensions (H x W x L) Weight
40
40
40
90
5. 3
90
40 40
55
6
40
1
P TR
Gig E-
HIROSE 12pin Connector
1
55
4- M32 Depth5 5
POWER / TRIG
3
98. 3
DC55IN / TRIG
4- M3 Depth5
Pin ACT. 1 2 3 4 5 6 40
LVDSGigEIn 1 (–) LVDS In (+) GigE connector TTL In 1 / 75 Ω terminator* (RJ-45) TTL Out 1 / open collector* TTL In 2 / 75 Ω terminator* GND * See manual for details
GigE Vision Interface 90 RJ-45 with locking screws 8
4- M3 Depth5
0. 3
4- M3 Depth5
4- M3 Depth 5
5. 3
90
5. 3
90
4- M3 Depth5
5. 3
5. 3
0. 3
Bottom view
HIROSE 6-pin
LINK
Rear view
90
1
G PIO
GigE TRD+(0) TRD–(0) TRD+(1)
Pin 5 6 7
4
TRD+(2)
8
0. 3
D C I N / T RIG
PO W E R TRIGG E R
Pin 1 2 3
2CCD Prism
98. 3
TRD–(2) TRD–(1) TRD+(3)
1
8
Gig E-1
1
8
Gig E-2
TRD–(3) 4- M3 Depth 5
4- M3 Depth5
Visible 1
Visible 2
50 㻵㼙㼍㼓㼑㼞㻌㻝 㻔㻌㼀㼞㼍㼚㼟㼙㼕㼠㼠㼑㼐㻌㻕
90
5. 3
40 30 20 10
㻵㼙㼍㼓㼑㼞㻌㻞 㻔㻾㼑㼒㼘㼑㼏㼠㼑㼐㻌㻕
High Dynamic Range Output
0 400
500
600
700
wavelength (nm)
Ordering Information AD-131GE
Gig E-
4- M3 Depth 5
6
* Use 3CCD-type lens
in a linear fashion that avoids the noise, shutter, and compression issues found in typical CMOS-based logarithmic or LinLog™ high dynamic range cameras. For more information, read the HDR tech note available at www.jai.com
P TR
98. 3
1
Serial No.
0.4L (11.49 µs) to 982L (31.761 ms) in 1L steps(28.72545µs) 1/13,000 sec. (2.4L) to (1.85)2 sec. Fine adjustment via GPIO 1/31 to 1/366 sec. (982L to 95L) 8 presets (1.0 to 0.45) or LUT 4-M3depth5 Shutter, gain,(depth0.2) black level, trigger mode, C Mount read-out mode, GPIO setup, ROI (GenICam 40 mandatory functions) Packet size (1476 to 16020 bytes), delayed (frame) read-out, inter-packet delay Power/hardwire trigger,GigE link /activity -5°C to +45°C 20 to 80% non-condensing -25°C to +60°C / 20 to 80% non-condensing 55 4- M3 Depth5 3 G (15Hz to 200 Hz XYZ) 50G CE (EN 61000-6-2, EN-61000-6-3), FCC part 15 class B, RoHS 12-24V DC ± 10%. 8.0 W typical (full frame @ 12V) C-mount (Max 4.0 mm thread)* 55(H) x 55(W) x 98.3(D) mm 340 g
By altering the shutter/gain settings of the two CCDs and fusing the two synchronized video streams either in-camera or during post-processing, the AD-131GE can provide more than double the dynamic range of standard CCD cameras (up to ~120 dB) but
G PIO
5. 3
GPIO
6.3
(0.25)
40
Indicators on rear panel Operating Temperature Humidity (operation) Storage temp./humidity Vibration Shock Regulations
5. 3
4- M3 Depth5
G PIO
40 (1.57)
55 (2.17) 40 (1.57)
GigE streaming protocol
4- M3 Depth5
0. 3
* Select by SW700
Configurable 25-in/14-out switch 12-bit counter based on pixel clock 20-bit counters with programmable length, start point, stop point, repeat Edge Pre-select, Pulse Width Control, Reset Continuous, Frame Delay, Sequence, PIV
Hardware trigger modes
Pulse Width Control GPIO plus Pulse Width Auto shutter LUT/Gamma Functions controlled via GigE Vision interface
2
90
Side view
Digital 2CCD monochrome high dynamic range camera
800
Company and product names mentioned in this datasheet are trademarks or registered trademarks of their respective owners. JAI A·S cannot be held responsible for any technical or typographical errors and reserves the right to make changes to products and documentation without prior notification.
(depth0.2)
(2.17)
4- M3 Depth5
August 2012
Synchronization GPIO Module Input/output switch Clock generator (one) Pulse generator (four)
90
5. 3
40
0 dB to +21 dB 0 dB to +21 dB (range adjustable) Int. X-tal 55 4-M3depth5
55
4- M3 Depth5 5. 3
40
(2.17) Master gain 40 (1.57) AGC
Electronic shutter Exposure time Abs
55
>54dB (0 dB gain, 10-bit) 8, 10 or 12-bit – single or dual-channel 0.7 Vp-p, w/o sync
55
S/N ratio Video output Auto-iris lens video 55
40
1296 (h) x 966 (v) 31.484 fps 1296 (h) x 966 (v) 62.9 fps 4-M3depth5 Programmable start line: 0 to 958 (depth0.2) Programmable height: 8 to 966 lines 1296 (h) x 483 (v) 53 fps 0.1 Lux (max. gain, shutter off, 50% video)
Vertical binning Sensitivity
4-M3depth5 Gain (depth0.2)
HIROSE HR10A-10R-12PB-01 Pin 1 Ground 2 +12V DC input 3 OPT In 2 (–)/GND (*) 4 OPT In 2 (+)/ Auto Iris video out (*) 5 OPT In 1 (–) 6 OPT In 1 (+) 7 OPT Out 1 (–) C Mount 8 OPT Out 1 (+) 9 OPT Out 2 (–) 40 C Mount 10 OPT Out 1 (+) 11 +12V DC input 40 12 Ground
40
Full Full - High frame rate Variable partial scan
5. 3 40
4.86 (h) x 3.63 (v) mm 3.75 (h) x 3.75 (v) µm 1296 (h) x 966 (v)
FCC seal
•ª—Þ?@DC-012
C Mount
40
Active area Cell size Active pixels Read-out modes
5. 3
Front view
40
Pixel Clock Frame rate full frame
DC In / GPIO
40
#1 #2
Dimensions
Connector pin-out
55
Sensor
AD-131 GE
Sensitivity (%)
Specifications
40
Specifications for AD-131 GE
Your contact D-A-CH Laser 2000 GmbH 82234 Wessling Phone +49 8153 405-0 E-Mail
[email protected] www.laser2000.de
NORDICS Laser 2000 GmbH 112 51 Stockholm Phone +46 8 555 36 235 E-Mail
[email protected] www.laser2000.se
FRANCE – Photonic Laser 2000 SAS 33600 Pessac Phone +33 5 57 10 92 80 E-Mail
[email protected] www.laser2000.fr
FRANCE – Telecom Laser 2000 SAS 78860 Saint-Nom la Bretèche Phone +33 1 30 80 00 60 E-Mail
[email protected] www.laser2000.fr
IBERIA Laser 2000 SAS 28034 Madrid Phone +34 650 529 806 E-Mail
[email protected] www.laser2000.es
