Transcript
1296 x 966
AD-132 GE
2 CCD Color HDR camera
Two Bayer color prism-mounted progressive scan CCDs (1/3”) Choice of high dynamic range, high frame rate, high S/N, or PIV mode 1296 (h) x 966 (v) active pixels per channel 3.75 µm square pixels RGB 24-bit/32-bit or raw Bayer 12-bit, 10-bit or 8-bit output 31 frames per second with full resolution Vairable partial scanning with user-definable height and starting line Programmable exposure from 11.49µs to 31.761ms GenICam Exposure Time Abs, pulse controlled, and auto shutter modes Sequence trigger mode for on-the-fly change of gain, exposure and ROI Built-in blemish compensation and shading compensation Look-up table (LUT) for gamma adjustment Separate AGC (automatic gain control) for each channel LVAL synchronous/asynchronous operation (auto-detect) Programmable GPIO with opto-isolated inputs and outputs Comprehensive control tool and SDK for Windows XP/Vista/7
31 FPS
GE
1/3” Bayer color IT CCD (ICX447) 1/3” Bayer color IT CCD (ICX447) 51.324 MHz 31 frames/sec.
C Mount
>52dB (Green ch., 0 dB gain, 10-bit) 30/24-bits RGB or 8, 10 or 12-bit raw Bayer 0.7 Vp-p, w/o sync 0 dB to +21 dB -7 dB to +10 dB 0 dB to +21 dB (range adjustable) Int. X-tal
Power Lens mount Dimensions (H x W x L) Weight
40
40
90
40
1
P TR
Gig E-
HIROSE 12pin Connector
1
98. 3
1
6
55
4- M32 Depth5 5
POWER / TRIG
3
98. 3
DC55IN / TRIG
4- M3 Depth5
40
40 (1.57)
Pin ACT. 1 2 3 4 5 6
LVDSGigEIn 1 (–) LVDS In (+) GigE connector TTL In 1 / 75 Ω terminator* (RJ-45) TTL Out 1 / open collector* TTL In 2 / 75 Ω terminator* GND * See manual for details
GigE Vision Interface 90 RJ-45 with locking screws 8
4- M3 Depth5
0. 3
4- M3 Depth5
4- M3 Depth 5
5. 3
90
5. 3
90
4- M3 Depth5
5. 3
5. 3
0. 3
Bottom view
HIROSE 6-pin
LINK
Rear view
90
1
Serial No.
G PIO
GigE TRD+(0) TRD–(0) TRD+(1)
Pin 5 6 7
4
TRD+(2)
8
0. 3
D C I N / T RIG
PO W E R TRIGG E R
Pin 1 2 3
2CCD Prism
98. 3
TRD–(2) TRD–(1) TRD+(3)
1
8
Gig E-1
1
8
Gig E-2
TRD–(3) 4- M3 Depth 5
4- M3 Depth5
————- (Transmitted CCD)
Imager 1 (Transmitted)
- - - - - - - - - - (Reflected CCD)
50 40
5. 3
High Dynamic Range Output
90
Imager 2 (Reflected)
30
20
0 400
500
600
Wavelength (nm)
Ordering Information AD-132GE
Gig E-
4- M3 Depth 5
6
10
in a linear fashion that avoids the noise, shutter, and compression issues found in typical CMOS-based logarithmic or LinLog™ high dynamic range cameras. For more information, read the HDR tech note available at www.jai.com
P TR
40
5. 3
GPIO
* Use 3CCD-type lens
By altering the shutter/gain settings of the two CCDs and fusing the two synchronized video streams either in-camera or during post-processing, the AD-132GE can provide more than double the dynamic range of standard CCD cameras (up to ~120 dB) but
G PIO
Digital 2CCD color high dynamic range camera
700
800
Company and product names mentioned in this datasheet are trademarks or registered trademarks of their respective owners. JAI A·S cannot be held responsible for any technical or typographical errors and reserves the right to make changes to products and documentation without prior notification.
Indicators on rear panel Operating Temperature Humidity (operation) Storage temp./humidity Vibration Shock Regulations
5. 3
July 2012
GigE streaming protocol
90
6.3
(0.25)
0.4L (11.49 µs) to 982L (31.761 ms) in 1L steps(28.725 µs) 1/13,000 sec. (2.4L) to45 2 sec. Fine adjustment via(1.85) GPIO 1/31 to 1/366 sec. (982L to 95L) Manual, one-push, continuous, fixed Gain range: 4-M3depth5 -7 dB to +10 dB (depth0.2) to 9000K 2800K C Mount 8 presets (1.0 to 0.45) or LUT 40 Shutter, gain, black level, trigger mode, read-out mode, GPIO setup, ROI (GenICam mandatory functions) Packet size (1476 to 16020 bytes), delayed (frame) read-out, inter-packet delay Power/hardwire trigger,GigE link /activity -5°C to +45°C 55 4- M3 Depth5 20 to 80% non-condensing -25°C to +60°C / 20 to 80% non-condensing 3 G (15Hz to 200 Hz XYZ) 50G CE (EN 61000-6-2, EN-61000-6-3), FCC part 15 class B, RoHS 12-24V DC ± 10%. 8.0 W typical (full frame @ 12V) C-mount (Max 4.0 mm thread)* 55(H) x 55(W) x 98.3(D) mm 340 g FCC seal
LUT/Gamma Functions controlled via GigE Vision interface
5. 3
4- M3 Depth5
G PIO
55
Pulse Width Control GPIO plus Pulse Width Auto shutter White balance
4- M3 Depth5
40
55 (2.17) 40 (1.57)
Electronic shutter Exposure time Abs
90
0. 3
* Select by SW700
12-bit counter based on pixel clock 20-bit counters with programmable length, start point, stop point, repeat Edge Pre-select, Pulse Width Control, Reset Continuous, Frame Delay, Sequence, PIV
Hardware trigger modes
4- M3 Depth5
40
55
4-M3depth5 (2.17) 2 (depth0.2) Configurable 25-in/14-out switch
90
5. 3
Side view
55
Master gain 55 R/B gain (2.17) AGC 4-M3depth5 40 (1.57) (depth0.2) Synchronization GPIO Module Input/output switch Clock generator (one) Pulse generator (four)
55
Gain
55
4- M3 Depth5 5. 3
40
S/N ratio Video output Auto-iris lens video
40
Sensitivity
40
HIROSE HR10A-10R-12PB-01 Pin 1 Ground 2 +12V DC input 3 OPT In 2 (–)/GND (*) 4 OPT In 2 (+)/ Auto Iris video out (*) 5 OPT In 1 (–) 6 OPT In 1 (+) 7 OPT Out 1 (–) C Mount 8 OPT Out 1 (+) 9 OPT Out 2 (–) 40 C Mount 10 OPT Out 1 (+) 11 +12V DC input 40 12 Ground
40
Full Variable partial scan
55
4.86 (h) x 3.63 (v) mm 3.75 (h) x 3.75 (v) µm 1296 (h) x 966 (v) 1296 (h) x 966 (v) 31.484 fps Programmable start line: 0 to 962 4-M3depth5 Programmable height: 8 to 966 lines (depth0.2) 0.7 Lux (max. gain, shutter off, 50% video)
•ª—Þ?@DC-012
5. 3 40
40
Active area Cell size Active pixels Read-out modes
5. 3
Front view
40
Pixel Clock Frame rate full frame
DC In / GPIO
40
#1 #2
Dimensions
Connector pin-out
40
Sensor
AD-132 GE
Transmittance (%)
Specifications
40
Specifications for AD-132 GE
Your contact D-A-CH Laser 2000 GmbH 82234 Wessling Phone +49 8153 405-0 E-Mail
[email protected] www.laser2000.de
NORDICS Laser 2000 GmbH 112 51 Stockholm Phone +46 8 555 36 235 E-Mail
[email protected] www.laser2000.se
FRANCE – Photonic Laser 2000 SAS 33600 Pessac Phone +33 5 57 10 92 80 E-Mail
[email protected] www.laser2000.fr
FRANCE – Telecom Laser 2000 SAS 78860 Saint-Nom la Bretèche Phone +33 1 30 80 00 60 E-Mail
[email protected] www.laser2000.fr
IBERIA Laser 2000 SAS 28034 Madrid Phone +34 650 529 806 E-Mail
[email protected] www.laser2000.es
