Datasheet For Cpl64 By Adlink Technology, Inc

Transcript

Digital CPL64 2-CH PCI Express® PoCL Frame Grabber Introduction The CPL64 is a PoCL (Power over Camera Link®) frame grabber that is based on the PCI Express® x4 interface, and supports two-channel Camera Link “base” configurations, multi-tap area and line scan cameras. The CPL64 frame grabber strikes a perfect balance between performance and cost. It is capable of simultaneously image acquisition from two completely independent Camera Link base configuration cameras, and supports image transfer rates up to 512 MB/s. PoCL Technology The PoCL (Power over Camera Link®) standard allows the camera link cable to supply power to the camera through the Camera Link connector without losing backward compatibility with the previous Camera Link® standard, this solution is particularly suitable for a small camera. Benefits of PoCL CAMERA Grayscale Camera RGB Camera Camera Link Digital • Easy installation • Reduce wiring (Single cable for digital I/F, and power) • Reduce camera size Features PCI Express® x4 compliant Supports 2-CH Camera Link® Base configuration Acquisition pixel clock rates up to 85 MHz PoCL (Power over Camera Link®) safe power compliant with auto detection 128 MB of 200 MHz DDR SDRAM for acquisition 4 TTL Digital Input/Output, and 2 trigger Input Supports 64-bit memory addressing Two serial communication ports Specifications Form Factor Video Input Camera Control Applications External Signal Input PCB/FPD/Wafer/Solar Cell surface inspections Medical research instrumentations Software Support OS Information • Windows® 8/7/XP Software Compatibility • C#/.NET/VC++/VB/C++ Builder/Delphi • Sample program included Software Recommendations • ADLINK CamCreatorTM Ordering Information CPL64 Power over Camera Link® (PoCL) Operating Environment Storage Environment Power Requirements Dimensions PCI Express® x4 compliant Camera Link® LVDS deferential signals Dual Base Configuration: Using two MDR26 pins connectors Maximum camera link data rate: 85 MHz Supports PoCL and standard Camera Link interface and auto detect LVDS camera control: CC1 to CC4 control signal in two MDR26 pins connectors External RS422 level ABZ phase deferential signal for encoder input 2 channels TTL level Line /Area trigger input 2 channels TTL level Line trigger start input 2 channels TTL level exposure output Line trigger bypass output (encoder mode only) 4 channels digital input; 4 channels digital output Power line output per channel : DC +12 V max @ 1 A Over-current Protection function, auto detect when non-PoCL cable or PoCL camera connected. 0˚C to +50˚C (32˚F to 122˚F) Humidity: 5% to 90% RHNC Temperature: 0°C to 70°C (32˚F to 158˚F) Humidity: 0 to 95% RHNC +12 V max @ 0.5 A +3.3 V max @ 1.6 A 167.65 mm x 111.15 mm (6.53” x 4.33”) (W x L) 2-CH PCI Express® x4 PoCL frame grabber Accessories Cabling PoCL Cable 5 M, power over Camera Link cable Camera Link Cable 5 M, robot type Updated January 29, 2013. ©2013 ADLINK Technology, Inc. All Rights Reserved. All speciications are subject to change without further notice.