Transcript
Io=3A non-isorated step-down DC/DC Converter module
MPM00 Series
Jul/10/2013
Package
General Descriptions The MPM series is a full molded hybrid IC which contains a non-insulated buck type DC/DC converter in one package. A power supply circuit can be composed in a simple way by using this hybrid IC which requires a small part count. By connecting only an input smoothing electrolytic capacitor, an output smoothing electrolytic capacitor and an output voltage setting resistor, the hybrid IC can be operated. Because of this simple composition, time required for design evaluation is significantly reduced. Since a power inductor is built in, it is not required to select and evaluate the inductor separately. By adopting a full molding package which can be fitted to the heat sink by screwing, board mounting can be made in self-supporting state without the heat sink subject to the output voltage setting and load conditions.
Full molding package SIP9
Pin 1,3 2 4 5,6,7 8,9
Features & Benefits Current mode type synchronization rectification PWM control system By connecting only an input smoothing electrolytic capacitor, an output smoothing electrolytic capacitor and an output voltage setting resistor, the hybrid IC can be operated. Since a power inductor is built in, it is not required to select and evaluate the inductor separately. Maximum efficiency 91 Output current range 0 to 3A Operating frequency 250kHz Reference voltage 0.5V±2% Built-in protection function Over Current Protection (OCP) Thermal Shutdown (TSD) Under Voltage Lockout (UVLO) Built-in phase compensation Built-in Soft-Start function
Symbol GND VIN FB OUT SW
Switching-Frequency-measurement
Electrical Characteristics Input voltage range
MPM01 : 9V to 40V MPM04 : 16V to 40V Output voltage range MPM01 : 1.8V to 12V MPM04 : 12V to 24V Output current IO = 3A Operating frequency: 250kHz
Applications FA machine / Communications equipment Domestic products Amusement machine / others
Table 1
Line up Product name
fSW
MPM01
VIN
VO
9V to 40V
(1)
16V to 40V
(2)
MPM04
IO
package
3A
SIP9
1.8V to 12V
250kHz (1)
Pin Assignment Function Ground terminal Input power supply terminal Feedback terminal Output terminal
12V to 24V
The minimum input voltage shall be either of 9V or VO+4V, whichever is higher.
(2)
The minimum input voltage shall be either of 16V or VO+4V, whichever is higher. And than Vin(MIN)36V in 20V
