Transcript
TM
CAMTAP to 4-pin XLR DC Cable for HDS-300
DC-C40M05
Operating Instructions
For using DC-C40M05. Before operating your DC-C40M05, please read this manual thoroughly and keep it for future reference. NIPROS accept no liability whatever for incidental damages arising out of the use or inability to use the product, including, but not limited to, damage to the camera, etc., corruption or loss of data, lost business revenue or suspension of business operations. NIPROS accept no liability whatever for damages arising from improper use not conforming to the instructions in the instruction manuals.
■Features
・ Connecting to the CAMTAP connector of the HDS-300, outputs the DC power from XLR 4-pin connector.
■Outsideview and Dimensions 0.4 m ∼ ∼
CAMTAP 2
4-pin XLR connector
CAMTAP connector
The orientation of the cable outlet of right-angle XLR connector can be adjusted appropriately according to the location of the connector connectoed, NOTE How to adjust the orientation of cable outlet. 1.Loosen and slide the cable boot A (bushing).
2.Remove the cover B.
3.Adjust the orientation of the cable outlet by turning the housing.
A
B
cable boot (bushing)
cable boot (bushing)
45 90
housing -90 -45
cover
A
cable outlet
Adjust
B
4.Position the cover B and tighten the boot A .
cover
0
■Specifications Specifications
Connector Cable Length
NOTE
1 XLR 4-pin connector, right-angle, female 1 CAM-Tap connector, male 0.4 m
4-pin XLR connector DC power output XLR 4-pin (female) 4 3
Features, design and specifications are subject to change without notice.
2
1
1
DC12V(G)
2
NC
3
NC
4
DC12V(＋)
