Denver Csw-1200 Subwoofer

Transcript

DENVER CSW-1200 12” SUBWOOFER Congratulations on your purchase of one of the finest subwoofer available for your vehicle today. Specifications: ● ● ● ● ● 12” Black Kevlar Cone ● 400 Watts Max. Power 70 Oz Subwoofer Magnet ● 200 Watts RMS 30-800 Hz Freq. response ● Heavy Duty Acoustic Carpeting Pushing Terminals ● 3” Black Vent Tube Dimensions: 45.00 cm X 40.00 cm X 38.50 cm **The CSW-1200 subwoofer requires an amplifier to operate properly. Installation: Location: Recommendations for Positioning the CSW-1200 in Your Vehicle: Car: Hatch Back to Trunk SUVs: & Mini Vans: Cargo Area Pick-Up Trucks: Behind Front Seat Wiring: If you are installing the CSW-1200 subwoofer to replace your existing subwoofer, disconnect the speaker wires the existing subwoofer from your vehicle. Place the CSW-1200 subwoofer in the location you selected in your vehicle and connect the existing speaker wires. Make sure to have the polarity of the speakers and wires correct (positive wire to positive speaker terminal and negative or ground wire to negative terminal) If you are installing the CSW-1200 subwoofer to be used in addition to the left & right channels, you will need a amplifier to power the CSW-1200 subwoofer. Consult amplifier installation manual for recommended connection method. Frequently Asked Questions: What is a subwoofer? A Subwoofer is a loudspeaker that reproduces only the lowest bass frequencies. You will not hear all of the music from a subwoofer, only the low bass. Why do I need an amplifier? Subwoofers require large amounts of power to produce deep heart pounding bass. While you can connect the CSW-1200 directly to your car stereo, most in-dash car stereos do not have sufficient power. An amplifier will provide the THUMP and BOOM you desire. I want to hook up two CSW-1200 subwoofers. How do I wire them? Connect one to the left channel of the amplifier and the second one to the right channel. You CAN wire the subs in parallel (+ to + &- to -) if your amplifier is 2 Ohm stable in “Bridged Mode”. Most amplifier are 4 Ohm stable when “Bridged”. Instructions on environment protection Do not dispose of this product in the usual household garbage at the end of its lifecycle; hand it over at a collection point for the recycling of electrical and electronic appliances. The symbol on the product, the instructions for use or the packing will inform about the methods for disposal. The materials are recyclable as mentioned in this marking. By recycling, material recycling or other forms of re-utilization of old appliances, you are making an important contribution to protect our environment. Please inquire at the community administration for the authorized disposal location. ALL RIGHTS RESERVED COPY RIGHT DENVER ELECTRONICS A/S www.denver-electronics.com