Transcript
DEUTSCH ENGLISH FRANÇAIS
NEDERLANDS ESPAÑOL
WE35
Product Overview 1.Band Selector (FM/MW/SW1-8) 2.Telescopic Antenna 3.Volume Control Dial 4.Hand Strap 5.Battery Compartment 6.Alarm Set Button 7.Alarm On/Off Button 8.Hour Button 9.Minute Button 10.Time Set Button 11.Radio Station Tuner 12.LCD Display 13.Earphone Jack
1.FM Display 2.MW Display 3.SW Display 4.Alarm Mode, On/Off 5.Frequency or Time 6.Display for medium Wave 7.Display for FM and Short Wave 8.PM Display
Inserting the Batteries 1. Open the battery cover, and insert 2 x AA 1.5V batteries (not included) into the Battery 2.
Compartment. Make sure the batteries are installed with the (+) and (-) in the correct position. Replace the batteries when the sound becomes weaker or when the reception becomes worse.
Radio Operation 1. To turn on the radio, rotate the Volume Control Dial upward until hear a click and use it to set the 2. 3. 4. 5. 6.
volume. Select the wave range (FM/MW/SW1-8) by sliding the Band Selector, and the selected wave range (FM/MW/SW) will appear on the LCD display. Use the Radio Station Tuner to tune the stations, and the tuned frequency will be shown on the LCD Display. Adjust the Telescopic Antenna for optimal reception (see Antennas) Insert an earphone plug into the Earphone Jack to listen privately, and the speaker will automatically switch off. To turn off the radio, rotate the Volume Control Dial downward until hear a click.
To Set the Time 1. 12:00 is set as the default time after the batteries have been installed. 2. Hold down the Time Set Button, and press the Hour or Minute Button simultaneously until the 3. 4. 5.
correct hour and minute is set. Release all buttons, and the clock will automatically start counting. The clock is operated in 12 hour format, and the PM Display will appear when the clock is reading PM. Please be sure PM and AM is correctly set for the clock. If you would like to check the time, rotate the Volume Control Dial downward until hear a click to turn off the radio, and the time will then be shown in the LCD Display.
To Set the Alarm 1. Make sure the radio is turned off 2. Hold down the Alarm Set Button, and press the Hour or Minute Button simultaneously until the correct hour and minute is set. Press the Alarm Set Button to check the set alarm time, and the alarm start time will appear in the LCD Display.
3.
Alarm Wake to Radio 1. After the alarm time is set, turn on the radio by using the Volume Control Dial. 2. Use the Band Selector to select the wave range, and tune the stations by using the Radio Station Tuner.
3. Rotate the Volume Control Dial downward until hearing a click to turn off the radio. 4. Press the Alarm On/Off Button to activate the alarm mode, and the alarm icon 5.
will appear in the LCD display. The radio will turn on to the set station automatically when the set alarm time is reached.
When the Alarm Sounds 1. Press the Alarm On/Off Button to turn off the alarm. The alarm icon alarm will sound again at the set time every day.
will remain and the
2. To deactivate the alarm function, press the Alarm On/Off Button again and the alarm icon will disappear.
Antennas 1. FM 2.
3.
Pull out the Telescopic Antenna (2) and adjust it’s length and angle for optimum reception. AM The sensitive ferrite core antenna inside the unit will provide excellent AM reception in most areas for optimum reception. Turn the unit in the direction which gives the best results since the ferrite core antenna is directional. SW 1-8 Extend the Telescopic Antenna (2) fully in a vertical position.
Specification Power Source : 2 x AA 1.5V batteries ( not included )
Frequency Range FM AM SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
87,5 – 108 530 – 1600 5.90 – 6.20 7.10 – 7.35 9.40 – 9.99 11.60 – 12.10 13.57 – 13.87 15.03 – 15.80 17.48 – 17.90 21.45 – 21.85
MHz KHz MHz MHz MHz MHz MHz MHz MHz MHz
