Transcript
Diagram for Connect Relay (500A rate) to Smart BMS
AA Portable Power Corp (http://www.batteryspace.com) Address: 860 S, 19th St, Unit A, Richmond, CA, 94804 Tel: 510-525-2328 Fax: 510-439-2808 Email:
[email protected] Prepared & Approved by Louis (01/10/08)
Master Controller
Voltage Sampling Module
89.6V LFE Battery pack
500A Relay
90VDC LOAD
12.8V LFE Power Supply for Relay
Hall Senor with Current Module
Note: -
“12.0VDC Relay Power Supply” will be control Open Circuit / Close Circuit by BMS (BMS not control relay but 12.0V Relay Power Supply. BMS will perform “Over-Current Alarm”, “low-Voltage Alarm”, “High Temperature, High Voltage Alarm” function with included 500A Relay Please refer picture for reference.
To Voltage Sampling Module Over-Current Alarm
High Temperature, High Voltage Alarm
(3 Pin Female Molex plug)
(3 Pin Female Molex plug)
low-Voltage Alarm (3 Pin Female Molex plug)
3 to 1 connector 12.0VDC Relay Power Supply
-
Tip: You may use included 3 pin male Molex plug & 9 pcs Receptacle Pin DIY between BMS and 12.0VDC relay Power supply ( Must DIY 3 to 1 connector )
-
In order to achieve balance function for each LiFePO4 single cell, please apply “Balance Module for (3.2V) LiFePO4 Battery Pack with variable balancing current “ for each single cell separately
-
In order to achieve balance function for each Li-Ion single cell, please apply “Balance Module for (3.7V) Li-Ion Battery Pack with variable balancing current “ for each single cell separately. Item will be available upon requested
