Transcript
DigiPedometer.
Contents
1.
Introduction & Warranty (PAGE 3)
2.
Watch Features (PAGE 5)
3.
Function Modes (PAGE 5)
4.
Pedometer Mode (PAGE 6)
5.
Timekeeping Mode (PAGE 7)
6.
Memory Mode (PAGE 11)
7.
Lock Function (PAGE 11)
8.
Specification (PAGE 12)
Functions Setting Time and Date Alarms Stopwatch Countdown Timer
2
1. Introduction & Warranty Thank you for your purchase of the Superdry Sport Digi Pedometer. The most advanced techniques were used during its manufacture, and it underwent stringent controls before it was released for sale. Your Superdry Sport Digi Pedometer is guaranteed against any defects in material or workmanship that may occur under normal use for a period of 24 months from the date of purchase. THE WARRANTY IS ONLY VALID WITH PROOF OF PURCHASE FROM YOUR AUTHORISED Superdry RETAILER. Under no circumstances will Superdry be liable for any incidental or consequential damages. The Warranty DOES NOT COVER: 1. Batteries, straps and watch glasses; 2. Damage or breakage caused from accident, maltreatment or mishandling; 3. Water penetration, except in watches marked as water resistant; 4. Tarnishing of case. WATCH CARE INSTRUCTIONS: Your Superdry Sport Digi Pedometer is carefully designed and produced. To fully utilize all the features, it is advisable to read this user manual carefully and use it in conformity with the notes mentioned below: 1. Battery. The battery should be replaced about every 18 months. Battery replacement requires the use of specialist tools, and should be carried out by an approved stockists or specialist repairer. IMPORTANT· Do not try to change the battery yourself as this invalidates your warranty. 2. Handling. Your Superdry Sport Digi Pedometer will not withstand extreme shocks or vibration. It is sensible to remove your watch before commencing rough work or situations where the watch could be damaged. Avoid exposing the Superdry Sport Digi Pedometer to extreme conditions for unreasonable amounts of time. Keep the Superdry Sport Digi Pedometer away from magnets or appliances which contain magnetic components such as speakers or motors as these items may ruin the sensors.
3
3. Water Resistance. Your Superdry Sport Digi Pedometer is 5 ATM water resistant. It is designed to withstand leisure type swimming, e.g. swimming baths, yachting and taking a shower. It is NOT designed to withstand sports high board diving, scuba type diving etc. Do not operate button while the watch is in contact with the water. 4. Cleaning. Clean the Superdry Sport Digi Pedometer occasionally with a soft cloth. If your watch has been used in salt water it should be rinsed off in fresh water and carefully dried. Disposal of Electric and Electronic Equipment The consumer has a significant role to play in reducing the impact of waste electrical and electronic equipment, batteries and accumulators on the environment, through re-using or recycling such articles. Some batteries and accumulators and some of the components used in electrical and electronic equipment may contain hazardous substances that can damage the environment and present a risk to human health if not properly disposed of. The crossed out wheelie-bin symbol on this product is to remind you that waste electrical or electronic products, batteries and accumulators should not be disposed of with household waste. If you are unable to re-use or recycle your article it should be disposed of at a civic amenity site/local authority recycling facilities.
DO NOT expose the Superdry Sport Digi Pedometer to strong chemicals such as fuel and alcohol as they will cause damage. DO NOT dispose of the Superdry Sport Digi Pedometer into fire as the battery inside the main unit may explode. WARNING! Make sure that you fully understand the functions and limitations of the Superdry Sport Digi Pedometer and it is NOT a professional medical device. Should you have any further questions regarding your fitness condition, please consult your doctor.
4
2. Watch Features
- 11 digits LCD screen displays hour, minute, second, day of the week and week. - 12-hour / 24-hour time format. - Full automatic calender from 2000 to 2099 (year). - Two groups of alarm and hourly time signal. - G-Sensor pedometer. - 50-day automatically record data (including date, calorie, activity time, distance). - Stopwatch (1/100 second stopwatch and split time). - Countdown timer. - Button tone. - EL backlight (This button has no button tone function).
Light
Up
Mode
Down
3. Function Modes
The Superdry Sports Digi Pedometer has 3 main function modes; pedometer mode, timekeeping mode and memory mode. To cycle through each of these press the MODE button. The home display of each mode is shown below:
MEMO
STEPS
Press MODE
Timekeeping Mode
Press MODE
STEPS
Memory Mode
Pedometer Mode
NOTE: You must be in pedometer mode to track activity continuously. Steps will not be recorded if you leave this mode. To remain in Pedometer mode, use the lock function by holding the UP button until ( use. To exit lock function, hold the UP button until (
) appears. Battery life can be reduced with regular
) disappears.
Each mode has been tailored to cater for specific aspects of your fitness programme. Pedometer - Track daily activity in 3 categories; steps taken, activity time, and distance travelled.
Timekeeping - Time/Date with 2 alarm groups, 1/100 stopwatch with split time, and countdown timer. Memory - Keeps a 50 day record of data collected (date, calorie, mileage & steps).
5
4. Pedometer Mode
NOTE: You must be in pedometer mode to track activity continuously. Steps will not be recorded if you leave this mode. To remain in Pedometer mode, use the lock function by holding the UP button until ( ) appears. Battery life can be reduced with regular use. To exit lock function, hold the UP button until (
) disappears.
Displays
In the pedometer mode the watch uses G-Sensor technology to track and record your daily activities. You must be in this mode to activate the G-Sensor and track activity. Within this mode you will be able to cycle through 3 different displays using the UP button - Step/Time, Step/Activity Time, Calorie/Mileage. These displays are shown below: STEPS
KCAL
STEPS
Press UP
Step / Time
Press UP
KM
Step / Activity Time
Calorie / Mileage
User Profile
To more accurately measure your step count, calorie burn and distance travelled you can set up an individual user profile. This will tailor the watch to you and your needs. - In pedometer mode, hold MODE button until KG/LB indicator starts to flash. - Press UP or DOWN button to adjust the flashing value. - Press MODE button to cycle through settings, as below diagram.
Cycle between with UP or DOWN
Press MODE
Stride Length (cm)
Sensitivity Low
Cycle between with UP or DOWN
Weight (lb)
Press MODE
To change each setting press UP or DOWN buttons accordingly. Press MODE
Metric / Imperial
Press MODE
Weight (Kg)
Press MODE
Metric / Imperial
Press MODE
NOTE: The flashing unit is the one which will change - shown below in GREEN.
Stride Length (in)
Sensitivity High
Metric/Imperial - Default is metric. Press UP or DOWN to switch between metric & imperial. Weight - Default weight is 60kg (132lb). Adjustable range is 20-200kg / 66-440lb. Stride Length - Default stride length is 70cm (28in). Adjustable range is 30-150cm / 12-59in. Sensitivity of G-Sensor - Default MIDDLE. Recommendation: LOW - Jogging / HI - Fast running.
6
Accuracy
- The most accurate counting state for the step counter is between 100-150 steps/min. If too fast or too slow accuracy will decline - so ensure to change the sensitivity to HIGH, LOW or MIDDLE when necessary. - The pedometer does not count non-standard steps as it simulates the usual motion when you walk or run. You should wear the watch before you begin walking or running. If not, the data may not record correctly.
5. Timekeeping Mode Functions
In the timekeeping mode you have 5 different functions to cycle between. Press UP button to cycle between each function.
Alarm 1
Setting Time and Date
Press UP
Press UP
Press UP Press UP
Date / Time
Alarm 2
Stopwatch
Countdown Timer
- In timekeeping mode, hold MODE button until 12H/24H indicator starts to flash. - Press UP or DOWN button to adjust the flashing value. - Hold UP or DOWN button to adjust the flashing value quickly. - Press MODE button to cycle through settings, as below diagram.
Hourly Time Signal
On/Off
Press MODE
PM
Min
Day
Month 7
PM
Second
Press MODE
Press MODE
Hour Press MODE
12H/24H
PM
Press MODE
PM
Press MODE
Press MODE
NOTE: The flashing unit is the one which will change - shown below in GREEN.
Year
Alarms Set an alarm and upon reaching the time the alarm icon will flash and alarm tone sounds with ‘BiBi’ for one minute. Press any button to stop after it starts to sound. Turning ON / OFF Alarm - In timekeeping mode, press UP button to switch to alarm mode. - Press DOWN button to turn ON / OFF alarm. After entering alarm state, alarm will automatically turn on. - When alarm is turned on, alarm icon will appear in all modes. (
ON )
Press DOWN
Setting an Alarm
On
Off
- Hold MODE button on alarm screen to enter alarm setting mode. - Press UP or DOWN button to adjust value. - Hold UP or DOWN button to adjust value quickly. - Press MODE to switch between settings. NOTE: The flashing unit is the one which will change - shown below in GREEN.
Press MODE
Set Hour
Set Minute
8
Stopwatch - From the time/date screen press UP 3x to get to stopwatch screen. - Press DOWN to turn on/pause stopwatch. - When paused, press LIGHT to clear the data. - While stopwatch is counting, press LIGHT to turn on split time. SPL indicator shows and stopwatch continues to count.
Initial Value
Press LIGHT to return to stopwatch
Press LIGHT to show split
Press DOWN to start/pause stopwatch
- Press LIGHT once more to release from split time (SPL) and return to stopwatch.
Stopwatch
SPL Display
Stopwatch
Pause Stopwatch
Press LIGHT to clear
Press DOWN to pause stopwatch
Press LIGHT to clear
Press DOWN to pause stopwatch
Clear
9
Pause Stopwatch
Countdown Timer
- From the time/date screen press UP 4x to get to countdown timer screen. - Hold MODE button to enter countdown time setting screen. - Press UP or DOWN button to adjust the value. - Hold UP or DOWN button to adjust the value quickly. - Press MODE to switch between hour and minute settings. - Press DOWN to start / pause counting down. - When paused, press LIGHT to return the display to countdown setting value. - When countdown timer is on, countdown icon (
) will flash to display in all modes.
- When countdown is complete screen displays 00:00.00. Countdown tone sounds with ‘BiBi’ for one minute. - Press any button to stop sound after it starts.
NOTE: Countdown time will automatically clear after entering countdown time setting screen.
Set Hour
Press MODE to set timer Set Minute
Press LIGHT to reset timer
Countdown time screen
Timer Reset
Timer Pauses Press DOWN to resume timer
Timer Resumes
10
Timer Set
Press DOWN to pause timer
Hold MODE to set hour
Press MODE to set minute
NOTE: The flashing unit is the one which will change - shown below in GREEN.
Press DOWN to start timer
Timer Starts Counting
6. Memory Mode
- The memory mode keeps a 50 day record of data recorded. The date is displayed at the top of the screen and the data cycles between steps, calories and mileage every one second. - Press mode to cycle through the main displays to get to memory mode. - Press UP or DOWN to view previous daily exercise records upward or downward. - To clear data, hold LIGHT till ‘ERASE’ flashes on screen. - Once ‘ERASE’ is shown, press LIGHT to clear data. - The watch will automatically exit from memory mode if no button is pressed for 30 seconds. MEMO
MEMO
MEMO
1 Second
1 Second
STEPS
CAL
Memory Step Display
KM
Memory Calorie Display
Memory Mileage Display
Press DOWN
MEMO
MEMO
STEPS
MEMO
Hold LIGHT
Memory Previous Day
Press LIGHT
Memory Erase
NOTE: The flashing ERASE shown in GREEN.
7. Lock Function
Cleared Memory
When you are in pedometer, timekeeping or memory mode, you can lock within this mode. This can be very helpful should you want to stay on a mode for an elongated period of time; in particular the pedometer mode. This will ensure you can keep recording data at all times. - In any mode hold UP button to lock display. - Screen will display lock icon (
)
- Hold UP button again to unlock the display.
11
8. Specifications - Module Size - Module Thickness (include buzzer) - Operational Temperature Range - Operational Voltage - Accuracy - Battery Code - Static average current - Alarm average current - EL lighten average current - Current for using pedometer - Battery life (90%)
: Φ33.20mm : 7.9mm : -10°C ~ 60°C : 3.0V : ±30sec/month : CR2025 (capacitance: 170m Ah) : ≤5.0u A (Static maximum current : 10.0uA) : ≤3.5m A (Alarm maximum current : 6.0mA) : ≤8.21m A (EL lighten maximum current : 12.0mA) : ≤3.5m A : ≥18 month
Battery life is calculated according to these standards: EL backlight illuminates 3 times (9 seconds) per day. Alarm tone sounds 30 seconds per day. Pedometer is used for an hour per day.
12
