Preview only show first 10 pages with watermark. For full document please download

Dish Pro Plus 44 Switch Installations Using Diplexers

   EMBED

Share

Transcript

Distribution Example 9 TV or DP Plus 44 SAT IN TV 3/4 OUT Audio/Video Jacks 110°/119° 2 DP Single Tuner or Legacy Receiver 3 61.5° or 148° 105° or 121° DP Plus Power Inserter TV 1 or DISH Pro Plus 44 Switch Installation Using Diplexers 1 Diplexers must not be installed between the power inserter and the switch. Splitter must be rated for minimum 54 to 806 MHz frequency range. CH 21-69 OUT DP Plus Separator The DP Plus 44 Power Inserter must be connected to the "To Power Inserter" Port 1. To minimize loss, a 4-way splitter was replaced with a 2-way splitter. 2 SAT IN SAT UHF/VHF 1 1 ANT TV IN 3/4 OUT Audio/Video Jacks Dual Tuner Receiver with Agile Modulated Output SAT UHF/VHF Use 2150 MHz RG6 cable between the LNBF and the satellite inputs of the receiver. Use drip loops to direct water away from F-connectors. Ground in accordance with national and local electrical codes. IN 2-Way Splitter OUT TV 2 (54-806 MHz) Unused splitter ports should be capped with 75 ohm terminators. Your installation may vary depending upon the losses in your system. Line amplification may be required. Ensure all components in the system operate within manufacturer specifications/ratings. 1 Diplexers must be DISH Pro compliant. 2 Can be a SuperDISH to support an alternate Super Dish location. 3 Refer to the DP Plus 44 Switch User's Guide for proper satellite feed input configuration requirements when Legacy receivers are installed using a DP Plus 44. TV 2 ©2004, EchoStar Technologies Corp. All rights reserved. Rev. 09/22/04