Transcript
DO / DMO Series • Mini-SIP SSR • Ratings to 2A @ 60 V DC • MOSFET or bi-polar transistor output • DC control • Normally open or normally closed output
PRODUCT SELECTION Control Voltage
1A
3-9 VDC 1.7-9 VDC 3-10 VDC
3A
DO061A (4), DO061A-B DO061B (4), DO061B -B DMO063 (4)
AVAILABLE OPTIONS
OUTPUT SPECIFICATIONS (1) Description Operating Voltage Range (47-63Hz) [VDC] Maximum Off-State Leakage Current @ Rated Voltage [µA] Maximum Load Current [Adc] Minimum Load Current [Adc] Maximum Surge Current [Adc] Maximum On-State Voltage Drop @ Rated Current Minimum Power Factor (with Maximum Load)
DO0
DMO
3-60 200 1.0 0.02 5 (1sec) 1.5 0.5
0-60 100 3.0 0 12 (10ms) 0.4 (2) 0.5
INPUT SPECIFICATIONS (1) Description Control Voltage Range Must Turn On Voltage Must Turn Off Voltage Typycal Input Current @ 5 VDC Nominal Input Impedance Maximum Turn-On Time [µsec] Maximum Turn-Off Time [µsec]
DO061A
DO061B
DMO063
3-9 VDC 3.0 VDC 1.0 VDC 15 mAdc 270 Ohm 50 50
1.7-9 VDC 1.7 VDC 0.8 VDC 15 mAdc 270 Ohm 50 150
3-10 VDC 3.0 VDC 1.0 VDC 20 mAdc 270 Ohm 50 300
GENERAL SPECIFICATIONS Description
Parameters
Dielectric Strength, Input/Output/Base (50/60Hz)(3) Minimum Insulation Resistance (@ 500 VDC)(3)
4000 Vrms
109 Ohm
Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation
8 pF -30 to 80 °C -30 to 125 °C 0.15 oz. (4.3g) Thermally Conductive Epoxy
GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Typical On-State Resistance=.13 3) Dielectric and insulation resistance are measured between input and output 4) Inductiv e loads should be diode suppressed
MECHANICAL SPECIFICATIONS DC C ONTR OL PIN 1: +DC LOAD PIN 2: -DC LOAD PIN 3: +DC CONTROL PIN 4: -DC CONTROL
THERMAL DERATE INFORMATION
AGENCY APPROVALS Rev. 040709
ANNEX - ENVIROMENTAL INFORMATION
