Preview only show first 10 pages with watermark. For full document please download

Ds-30220_manual_english_20110614

   EMBED

Share

Transcript

USB 3.0 2 ports PCI Express Card User Manual All brand names and trademarks are properties of their respective owners. Features and Benefits  Compliant with Universal Serial Bus 3.0 specification revision 1.0  Supports the following speed data rates as follows: Low-speed (1.5Mbps) / Full-Speed (12Mbps) / High-Speed (480Mbps) /Supper-Speed (5Gbps)   Supports 2 downstream ports for all speeds Supports all USB compliant data transfer types as follows: Control /Bulk /Interrupt / Isochronous transfer  Supports USB legacy function  Compliant with PCI Express Base Specification 2.0  Supports PCI Bus Power Management Interface Specification revision 1.2 Bus Interface  PCI-Express x 1 Connector  2 x Downstream ports Page 2 System Requirements  Windows® XP/Vista/7 (32/64 bit)  PCI Express-enabled system with an available PCI Express slot Package Contents  1 x USB 3.0 2 ports PCI Express Card  1 x User Manual  1 x Driver CD  1x Low-Profile bracket Note: Contents may vary depending on the market/country. Hardware Installation 1. Turn Off the power to your computer. 2. Unplug the power cord and remove your computer’s cover. 3. Remove the slot bracket from an available PCIe slot. 4. To install the card, carefully align the card’s bus connector with the selected PCIe slot on the motherboard. Push the board down firmly. Page 3 5. Connect the system power source to the board’s power connector. 6. Replace the slot bracket’s holding screw to secure the card. 7. Replace the computer cover and reconnect the power cord. Driver Installation Important: If your system doesn’t boot to Windows properly with our card installed, check with your system’s manufacturer for the latest system firmware update. For Windows® XP/Vista/7 (32/64 bit) Place the installation CD into a CD-ROM drive and setup should launch automatically. If setup does not launch, use Windows Explorer to native to the appropriate CD-ROM driver and run the installation program. Follow the instructions on screen to install the driver. After driver installation is complete, you must restart your computer. Page 4 To Verify Driver Installation 1. Right click My Computer, then click Manage. Click Device Manager. 2. Double click Universal Serial Bus controllers option. - NEC Electronics USB 3.0 Host Controller - NEC Electronics USB 3.0 Root Hub Page 5