Ds Talexx C350-2 Pwm Dimmer En

Transcript

PWM dimmer 350 mA for Ueos modules µCR 21 Ucontrol LED C350-2 4 channel PWM dimmer 160 150 type article number supply control inputs supply voltage Uin max. supply current number of control inputs input frequency PWM voltage max. LOW voltage min. HIGH voltage max. current input at 26 V number of output channels output signal 3 output frequency dimming range output voltage 1 output current max. cable length (converter → PH output O Packaging: box of 12 D Properties: • universal PWM control inputs • 350 mA current PWM output signal • suitable for combining with controls from TridonicAtco • integrated strain-relief and terminal cover • connection cable: cross section 0.5 – 1.5 mm² • over voltage shutdown AS E Highlights: • 4 channel constant-current dimming controller for 350 mA ueos modules • dimming 1 – 100 % 3 • exact load balancing per output channel • wide input voltage range • slim housing U 30 T 30 module) ambient temperature ta max. case temperature tc weight 1 depends on supply voltage Uin and number of umodule (ULED max. = Uin – 5 V) 2 SELV to be provided by the supply unit, e.g. uconverter K211 3 Dimming quality is determined by the PWM transmitter Data sheet 10/09-864-1  We reserve the right to make technical changes without prior notice. V DC A – Hz V V V mA – – Hz % V A m °C °C g LED C350 4 channel PWM dimmer 86458693 24 – 48 (SELV 2) 1.5 4 x PWM 120 – 250 18 – 26 3 13 3 4 (e.g. RGBA) current-PWM 120 – 250 1 – 100 24 V: 3-20 / 48 V: 28-43 (SELV 2) 0.35 / channel 5 -20 → +45 70 55 Designed according to: EN 61347-1 EN 61347-2-13 EN 61547 EN 62384 PWM dimmer 350 mA for Ueos modules Wiring examples Ueos modules: eos P211 + Uin – Uin Com 1-4 Ch 1in Ch 2in Ch 3in Ch 4in + Ch 1-4 + Ch 1-4 – Ch 1 control LED C350 PWM-Dimmer – Ch 2 – Ch 3 – Ch 4 eos P211 G B R B R G O Wiring guidelines • The cables should be run separately from the mains connections and mains cables to ensure good EMC conditions • The maximum secondary cable length at the terminals is 5 m. The LED wiring should be kept as short as possible to ensure good EMC Wiring type and cross section The wiring can be in flexible cable with ferules or solid. For perfect function of the push-wire terminals the strip length should be 8.5 – 9.5 mm. D Release of the wiring Press down the “push button” and remove the cable from front. G B T R U + Uin + Ch 1-4 – Uin + Ch 1-4 Com 1-4 – Ch 1 control Ch 1in LED C350 PWM-Dimmer – Ch 2 Ch 2in – Ch 3 Ch 3in – Ch 4 Ch 4in AS E wire preparation: 0.5 – 1.5 mm² 8.5 – 9.5 mm PH Information about the correct handling of LEDs can be found in the u brochure “Installation instructions and Guidelines” Ê www.tridonicatco.com Data sheet 10/09-864-1  We reserve the right to make technical changes without prior notice.