Preview only show first 10 pages with watermark. For full document please download

Dtk-db Series Installation Instructions Surge Protection For Data Communication Systems

   EMBED

Share

Transcript

DTK-DB SERIES SURGE PROTECTION FOR DATA COMMUNICATION SYSTEMS INSTALLATION INSTRUCTIONS NOTE: THIS DEVICE IS INTENDED FOR INDOOR USE ON RS232 OR RS485 DATA COMMUNICATION CIRCUITS UTILIZING 9,15, OR 25 PIN D-SUB CONNECTORS. 1. THIS DEVICE MUST BE CONNECTED IN SERIES BETWEEN THE FIELD WIRING AND THE EQUIPMENT TO BE PROTECTED. 2. USING THE APPROPRIATE CABLE ASSEMBLIES (9, 15, OR 25 PIN), CONNECT THE INPUT FROM FIELD WIRING TO THE FEMALE D-SUB CONNECTOR AND CONNECT THE OUTPUT TO PROTECTED EQUIPMENT TO THE MALE D-SUB CONNECTOR. 3. ALLOW THE SURGE PROTECTOR REACTION TIME BY PROVIDING 3-5 WIRE FEET BETWEEN THE DTK- UNIT AND THE EQUIPMENT TO BE PROTECTED. 4. SECURELY MOUNT THE BASE USING THE DOUBLE SIDED TAPE (SUPPLIED), OR TWO #8 SCREWS (NOT SUPPLIED). 5. MAKE SURE THE WIRE DISTANCE FROM THE SURGE PROTECTOR TO PROTECTED EQUIPMENT IS GREATER THAN THE WIRE DISTANCE FROM THE SURGE PROTECTOR TO GROUND. 6. USE ONE COMMON GROUND PER SYSTEM TO ELIMINATE THE POSSIBILITY OF A DIFFERENCE IN GROUND POTENTIALS. 7. IF YOU HAVE ANY QUESTIONS CALL TECHNICAL SUPPORT AT: 1-888-472-6100. 3.84" GND DB SERIES LOW VOLTAGE SURGE PROTECTION FOR DATA COMMUNICATION SYSTEMS RS-485 DB-9 DB-15 DB-25 RS-232 ZDB-9 ZDB-15 ZDB-25 FEMALE D-SUB INPUT / MALE D-SUB OUTPUT 2X Ø.19" 1.40" 1.10" .13" 4.30" TITLE: Diversified Technology Group, Inc. 2.45" INSTALLATION INSTRUCTIONS DTK-DB Series APPROVED BY: MATERIAL: FINISH: 1720 Starkey Road Largo, Florida 33771 Tel. 727-812-5000 Fax 727-812-5026 DRAWN BY: RWM DATE: 8/12/03 REVISED: DWG NO. INT-100040-001 PART NO. 200707 REV. 0