Preview only show first 10 pages with watermark. For full document please download

Dts 397 Asi Splitter

   EMBED

Share

Transcript

DTS 397 ASI Splitter *HQHUDO The active splitter distributes the electrical input data stream (DVB/ASI) to 8 electrically equivalent outputs. DTS 397 is a 19" module requiring 1 rack unit (1 RU) in the 19" rack. One ASI test port is located on the front panel. Six LEDs indicate the operating conditions. At the module's back there are the electrical input and output ports. The device is equipped with 2 power supplies. This makes it possible to operate the device at different circuits if redundancy is needed.  03(*DQG'9% &RPSOLDQW  Redundant power supply  0RGXOH58 )XQFWLRQ According to DVB, the input data stream can be composed byte-wise and/or packet-wise. However, the MPEG-2 data in the ASI signal stream is made available at the outputs as packets. Signal Processing in the ASI interface is done according to DVB, Asynchronus Serial Interface (ASI). Only MPEG data meeting the MPEG-2 standard ISO/IEC 13818-1 is transmitted. Features  MPEG-2 and DVB Compliant  Automatic 188/204 byte detection  DVB/ASI Input and DVB/ASI Outputs (1 to 8, 1 Test Port)  Useful Data Rate 0.1 to 200 MBIT/S  Redundant Power Supply  19" Module, 1 RU 969 Horsham Road l Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 l [email protected] DTS 397 ASI Splitter Specifications Inputs Configuration 1 x ASI 1 x ASI Redundancy Configuration port • Auto Redundancy input will be switched automatically • Remote Redundancy input controlled by remote switch (Sub-Min-D Contact 4/5) Outputs 8 x ASI 1 x ASI Test • ON ASI ports BNC, 75 Ω, (EN 50083-9) Alarm signaling output LED Display • OFF D-Sub-9 A-Alarm B-Alarm Redundancy input active (switching in case of input error) Redundancy input not connected (no switching) Power Supply Mains voltage System Fault, Error Data processing, Datarate < 0,1 Mbit/s, no useful MPEG-2 data, Signal detected, ASI-Redundancy input active Power consumption 100 VAC to 240 VAC 50/60 Hz, Redundant power supply < 10 Watt General Dimensions W/ H/ D (mm) Weight 482.6/ 44.45/ 158 ; 19”, 1 RU 3.5 kg Rear View Specifications Subject To Change Without Notice 969 Horsham Road l Rev 04-13 Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 © Toner Cable Equipment, Inc. l [email protected]