Transcript
E-Unit lockout switch
Item #517
Lockout Switch assembly is prewired and insulated with appropriate heat shrink tubing. Lockout switch will lock any DALLEE E-Unit into the Forward or Neutral position. The switch will prevent the E-Unit from sequencing beyond the startup position. If you have forward as your startup position, then with the switch engaged the E-Unit will start in forward. Likewise, if the startup is set for Neutral, then you will stay in Neutral. When the switch is set off, you will sequence as normal. Installation: Mount the switch in an appropriate location that allows the end connector to reach the existing E-Unit's "LOCK" connector. Drill a 7/32" hole. Using both nuts with the locking washer, mount the switch. Plug the connector into the "LOCK" socket on the E-Unit board. Refer to your E-Unit instructions for this location (usually in the top left of the E-Unit board). Be sure not to puncture or pinch either of these wires or the insulation around the switch. Doing so could damage the E-Unit.
246 W. Main St. Leola, PA 17540 (717) 661-7041 www.dallee.com
