Earphones And Accessories - Av-iq

Transcript

Earphones and Accessories Single Ear Bud Part Number: LA-161 • Use with any of Listen’s receivers. • Economical, low cost hearing option. ‡6LQJOHHDUIULFWLRQÀW • Replaceable ear cushions available (Specify LA-163). • The receiver’s antenna is built into the headphone cord. 6SHFLÀFDWLRQV Impedance 32 Ohm +/- 15% Maximum Input 30 mW Connector 3.5 mm mono Cable Length 36 in. (92 cm) Weight 4 oz. (113 g) Dual Ear Bud Part Number: LA-162 • Use with any of Listen’s receivers. ‡'XDOHDUIULFWLRQÀW • Replaceable ear cushions available (specify LA-163). • Economical cost hearing option. • The receiver’s antenna is built into the headphone cord. 6SHFLÀFDWLRQV Impedance 32 Ohm +/- 15% Maximum Input 30 mW maximum Connector 3.5 mm mono Cable Length 36 in. (92 cm) Weight 4 oz. (113 g) Ear Bud Replacement Cushions Part Number: LA-163 • Package of 20. • Fits LA-161 Single Ear Bud and LA-162 Dual Ear Buds. Listen Technologies Corporation • 14912 Heritagecrest Way • Bluffdale • Utah 84065-4818 U.S.A. +1.801.233.8992 • +1.800.330.0891 North America • +1.801.233.8995 Fax Listen Technologies Corporation All rights reserved 102407 Earphones and Accessories Page 1 Ear Speaker Part Number: LA-164 6SHFLÀFDWLRQV • Use with any of Listen’s receivers. • Single ear clip that doesn’t mess up hair. • Easily cleaned (solid plastic speaker). • Strong volume output. • The receiver’s antenna is built into the headphone cord. Impedance 32 Ohm +/- 15% Maximum Input 100 mW Connector 3.5 mm mono Cable Length 36 in. (92 cm) Weight 4 oz. (113 g) Stereo Headphones Part Number: LA-165 • Dual ear over-the-head style. • Traditional headset design. ‡(DUFXVKLRQVIROGÁDWIRUFRQYHQLHQWVWRUDJH • Replaceable ear cushions available (specify LA-167). • The earphone cord works as the receiver’s antenna. (DUSKRQH6SHFLÀFDWLRQV Impedance 32 Ohm +/-15% Maximum Input 100 mW Connector 3.5 mm stereo Cable Length 36 in. (92 cm) Weight 5 oz. (142 g) Neck Loop Part Number: LA-166 • Use with any of Listen’s receivers. • Use with any hearing aid equipped with a “T” coil. • The receiver’s antenna is built in to the headphone cord. 6SHFLÀFDWLRQV Impedance 12 Ohm +/-15% Maximum Input 2 W (75mW nominal) Connector 3.5 mm mono Cable Length 37 in. (94 cm) Circumference 16 in. (41 cm) from base of loop coil Listen Technologies Corporation • 14912 Heritagecrest Way • Bluffdale • Utah 84065-4818 U.S.A. +1.801.233.8992 • +1.800.330.0891 North America • +1.801.233.8995 Fax Listen Technologies Corporation All rights reserved 102407 Earphones and Accessories Page 2 Replacement Cushions for Stereo Headphones (10) Part Number: LA-167 • Package of 10. • Fits LA-165 Stereo Headset. Sanitary Covers for Stereo Headphones (10) Part Number: LA-168 • Use with Listen Stereo Headsets (LA-165) • FDA approved sanitary cover for ear cushions. • Package of 10 Behind-the-Head Stereo Headphones Part Number: LA-170 • Dual ear output. • Behind-the-Head design allows usage with hard hats and doesn’t mess up hair. ‡)ROGVÁDWIRUFRQYHQLHQWVWRUDJH • Replaceable ear cushions available (specify LA-167) • The earphone cord works as the receiver’s antenna. 6SHFLÀFDWLRQV Impedance 32 Ohm +/- 15% Maximum Input 100 mW Connector 3.5 mm stereo Cable Length 36 in. (92 cm) Weight 5 oz. (142 g) Listen Technologies Corporation • 14912 Heritagecrest Way • Bluffdale • Utah 84065-4818 U.S.A. +1.801.233.8992 • +1.800.330.0891 North America • +1.801.233.8995 Fax Listen Technologies Corporation All rights reserved 102407 Earphones and Accessories Page 3 Over-the-Head Microphone and w/Earphone Part Number: LA-272 6SHFLÀFDWLRQV • Use with Listen’s LT-700 Portable Transmitter and Listen Receivers or other audio input. • Two 3.5 mm connectors - one for the microphone and the other for the earphone. • Picks up voice and transmits to receivers. • Uni-directional mic picks up audio from only one direction. • Superior aural performance. • Ideal for unobtrusive placement and high performance. • Directional microphone picks up audio directly in front of the mic. • Does not pick up unwanted audio and noise in all directions • The transmitter and receiver antenna is built in to this microphone/headphone cord. Impedance Less than 2.2K ohm Connector 3.5 mm mono Phantom Power 3 VDC required Cable Length 36 in. (92 cm) Weight 8 oz. (227 g) Portable Receiver Consumer Camcorder Cable Part Number: LA-265 • Use with any of Listen’s receivers. • Used to provide direct audio feed to a consumer camcorder or other recording device. 6SHFLÀFDWLRQV Connectors Male 3-pin XLR and male 3.5 mm stereo In-line Resister Pad 40 dB Cable Length 4 ft. (121 cm) Portable Receiver Professional Camcorder Cable Part Number: LA-266 • Use with any of Listen’s receivers. • Used to provide direct audio feed to a professional camcorder or other recording device. 6SHFLÀFDWLRQV Connectors Male 3-pin XLR and male 3.5 mm stereo In-line Resister Pad 40 dB Cable Length 4 ft. (121 cm) Listen Technologies Corporation • 14912 Heritagecrest Way • Bluffdale • Utah 84065-4818 U.S.A. +1.801.233.8992 • +1.800.330.0891 North America • +1.801.233.8995 Fax Listen Technologies Corporation All rights reserved 102407 Earphones and Accessories Page 4 DIS Stereo Headphones Part Number: DH-6021 • Durable reinforced cable. • 90° stereo connector. • Special designed for speech intelligibility. • Replaceable ear pads. 6SHFLÀFDWLRQV Audio Interconnections Physical Frequency response 35 Hz - 15 kHz Nominal Impedance 600 Ohm Loudspeaker maximum power 86 dB @ 1 kHz Load Rating 100 mW Distortion <1.5% Headphone connector One (1) 90° male 3.5 mm (0.14 in.) stereo connector Cable Length 62.0 in. (1.6 m) Color Black Unit Weight 1.94 oz. (55 g) Shipping Weight 1.0 lbs. (0.45 kg) DIS Stethoscope Stereo Headphones Part Number: DH-6023 • Super light weight. • 90° stereo connector. • Stethoscope style for minimum discomfort to the delegate. • Replaceable ear pads. 6SHFLÀFDWLRQV Audio Interconnections Physical Frequency Response 100 Hz - 4 kHz Nominal Impedance 32 Ohm Max input level 20 mVA Headphone connector One 91) 90° male 3.5 mm (0.14) stereo connector Cable Length 62.0 in. (1.6 m) Color Black Unit Weight 0.63 oz. (18 g) Shipping Weight 1.0 lbs. (0.45 kg) DIS Clip Headphones Part Number: DH-6025 • Lightweight. • Replaceable ear pad. • 90° stereo connector. 6SHFLÀFDWLRQV Audio Interconnections Physical Freqency Response 100 Hz - 4kHz Nominal Impedance 32 Ohm Max input level 10mVA Headphone connector One (1) 90° male 3.5 mm (0.14 in.) connector Cable Length 62.0 in. (1.6 m) Color Black Unit Weight 0.35 oz. (10 g) Shipping Weight 1.0 lbs. (0.45 kg) Listen Technologies Corporation • 14912 Heritagecrest Way • Bluffdale • Utah 84065-4818 U.S.A. +1.801.233.8992 • +1.800.330.0891 North America • +1.801.233.8995 Fax Listen Technologies Corporation All rights reserved 102407 Earphones and Accessories Page 5