Ecs-h Charger Quick Start Guide

Transcript

Quickstart Guide ECS-H Battery Handle Charger Quickstart Guide ECS-H Battery Handle Charger ECS-H with CR2500 and battery handle The ECS-H charger is designed to firmly and reliably hold and charge wireless Code bar code readers equipped with a battery handle. Included: ECS-H with CR2500 and battery handle The ECS-H charger is designed to firmly and reliably hold and charge wireless Code bar code readers equipped with a battery handle. Included: ECS-H Charger Power Supply (if ordered) Weighted Base (If ordered) ECS-H Charger Screws (If weighted base ordered) Power Supply (if ordered) Weighted Base (If ordered) Screws (If weighted base ordered) Installation Instructions: Installation Instructions: 1. Plug the power supply into the charger and wrap the cable around the post, as indicated in the diagram on the charger. Slide the cable through the channel cut out. (Figures 1 and 2) 1. Plug the power supply into the charger and wrap the cable around the post, as indicated in the diagram on the charger. Slide the cable through the channel cut out. (Figures 1 and 2) Figure 1 2. If a weighted base plate was ordered, place the ECS-H onto the weighted base and secure with the screws provided (Figure 3). Plug in power supply into the wall socket (or USB port if USB Charge Cable ordered). Figure 1 2. If a weighted base plate was ordered, place the ECS-H onto the weighted base and secure with the screws provided (Figure 3). Plug in power supply into the wall socket (or USB port if USB Charge Cable ordered). Figure 2 Figure 2 3. If a weighted base was not ordered, mount the charger to a surface for added stability. Note: Because surface types differ, mounting screws have not been included. Plug in power supply into the wall socket. 3. If a weighted base was not ordered, mount the charger to a surface for added stability. Note: Because surface types differ, mounting screws have not been included. Plug in power supply into the wall socket. Figure 3 Charging Instructions: Figure 3 Charging Instructions: Firmly seat the battery handle in the charger. When the charging clips are engaged, the LED will turn on. Firmly seat the battery handle in the charger. When the charging clips are engaged, the LED will turn on. • Green LED indicates battery handle is fully charged. • Red LED indicates battery handle is charging. • Green LED indicates battery handle is fully charged. • Red LED indicates battery handle is charging. Battery handles ship with approximately 50% battery life and should be completely charged before initial use. Approximate time to charge a depleted battery is 4 hours. Note: In certain reader configurations, the LED on the charger may never turn green. Battery handles ship with approximately 50% battery life and should be completely charged before initial use. Approximate time to charge a depleted battery is 4 hours. Note: In certain reader configurations, the LED on the charger may never turn green. C007537_03_ECS-H_QuickStart Guide © Copyright. 2012. Code Corporation C007537_03_ECS-H_QuickStart Guide © Copyright. 2012 Code Corporation