Preview only show first 10 pages with watermark. For full document please download

Egtr-sa1712-16 - Eminence Speaker

   EMBED

Share

Transcript

Specification Nominal Basket Diameter Nominal Impedance* Power Rating** Watts Music Program Resonance Usable Frequency Range*** Sensitivity Magnet Weight Gap Height Voice Coil Diameter 12’’, 305mm 16 ohms 100W 101Hz 80Hz-5.5kHz 100.1 34oz .32’’,8.00mm 1.75’’,44.5mm Thiele & Small Parameters Resonant Frequency (fs) DC Resistance (Re) Coil Inductance (Le) Mechanical Q (Qms) Electromagnetic Q (Qes) Total Q (Qts) Compliance Equivalent Volume (Vas) Peak Diaphragm Displacement Volume (Vd) Mechanical Compliance of Suspension (Cms) BL Product (BL) Diaphragm Mass inc. Airload (Mms) Efficiency Bandwidth Product (EBP) Maximum Linear Excursion (Xmax) Surface Area of Cone (Sd) Maximum Mechanical Limit (Xlim) 101Hz 13 1.05mH 14.69 1.21 1.12 30.66 ltr./1.08cuft 41.00cc .08mm/N 14.4 T-M 30.5 grams 83 .8mm 519.5cm2 N/A EGTR-SA1712-16 Lead / Rhythm Guitar, American Voiced Mounting Information Recommended Enclosure Volume Sealed Vented Overall Diameter Baffle Hole Diameter Front Sealing Gasket Rear Sealing Gasket Mounting Holes Diameter Mounting Holes B.C.D. Depth Net Weight Shipping Weight N/A N/A 12.25’’, 311.15mm 11.00’’, 279.40mm fitted as standard fitted as standard .25’’, 6.35mm 11.72’’, 297.69mm 5.00’’, 127.00mm 7.50 lbs, 3.40 kg Materials of Construction Coil Construction Coil Former Magnet Composition Motor Details Basket Material Cone Composition Cone Edge Composition Dust Cap Composition Copper Polyimide Ferrite Standard Core Steel Full Molded Paper Paper Zurette * Please inquire about alternative impedances. ** Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment. *** The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms. Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25” supplied microphone (software calibrated) mounted 1m from wall/baffle | 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu.ft. chamber with fiberglass on all six surfaces (three with custom-made wedges)