Transcript
TECHNICAL DATA Dwg:
DS-S08-048
Rev:
A
Date:
SCAVENGER E SERIES 1/17/07
Scavenger
Section
Tab
EJ 100-4 Ejector
Page
MOTOR SPECIFICATIONS NEMA design B, squirrel cage induction, oil filled, non toxic oil Enclosed submersible Class F, rated at 155° C Three Phase: Installer must provide external motor overload protection device such as a contactor w/ thermal relay, and circuit breaker for short circuit protection per N.E.C. standards. Leakage: DI Moisture Detection in Seal Sensing Chamber 1.1 ± 10% from name plate rating
Motor Design Motor Type Insulation Class Motor Protection
Service Factor Voltage Tolerance
MOTOR DATA, 60Hz Model EJ 100D-4
Phase 3* 3* 3
Output Power bhp 10.0 10.0 10.0
Volts 208-230 460 575
Full Load Amps 31.0-28.0 14.0 11.0
Locked Rotor Amps 141.5-128 64 51
NEMA Code Letter F F F
Pole/ Speed (rpm) 4/1750 4/1750 4/1750
* These three phase motors are tri-voltage, 208/230/460. MATERIALS of CONSTRUCTION Cast Iron ASTM A48 Class 30 Cast Iron ASTM A48 Class 30 Cast Iron ASTM A48 Class 30 Cast Iron ASTM A48 Class 30 Cast Iron ASTM A48 Class 30 Cast Iron ASTM A48 Class 30 AISI 304 Stainless Steel Non-toxic white mineral oil (Marcol 52) AISI 304 Stainless Steel Buna-N AISI 420 Stainless Steel Single row ball bearing Double row ball bearing Rotating carbon face w/ stationary ceramic face. Rotating carbon face w/ stationary ceramic face. Includes V-ring lip seal for lower seal protection. Optional: Silicon Carbide mechanical seal.
Upper Motor Lid Motor Housing Oil Chamber Volute Bottom Plate Impeller Lifting Bail Oil (motor & oil chamber) External Hardware O-Rings Motor Shaft Upper Bearing Lower Bearing(s) Upper Shaft Seal (secondary) Lower Shaft Seal (primary)
DIMENSIONS, WEIGHT, AND MISC. Pump weight, lb. (kg) Maximum submergence, ft. (m) Discharge size, standard Discharge type Maximum temp. of pumped fluid Agency Approvals
170 (77) 65 (20) 4 inch horizontal Flange with standard ANSI class 125 bolt pattern 40°C continuous, 50°C intermittent UL 778 and CSA C22.2-108
CABLE SPECIFICATIONS POWER CABLE 8/4 SEOOW 12/4 SEOOW
Specifications subject to change without notice
VOLTAGE 208-230/460 575
DIAMETER 0.76in (19.3mm) 0.65in (16.4mm)
LENGTH
OUTER JACKET
32 ft (10m)
Thermoplastic elastomer
