Transcript
FLBY07GGAWFD FLBY07GGAWF
Electrolux Major Appliances International, 10200 David Taylor Drive, Charlotte, NC 28262, USA Made in china
BEFORE USING Using process Washing attentions .......................5 Use of detergent............................5 Washing sequence........................6 After using..................................8 Clean lint filter.............................. 8 Clean machine.............................. 8 When the remained water is frozen..8 Trouble-shooting...........................9
Content Before using Name of part ............................1 Attention ..................................2 Installation and adjustment ........3 Main functions ..........................4 Preparation before washing........4
Features: Spiral strong water flow,wash more clean. New wash mode,remove the dirt on the clothes thoroughly. Multi water level indication,save water and energy. Rinse and foam-removing spinning,clean and fast.
Inlet
Knob
Control panel
Spin cover
Wash cover Wash tub
Spin tub inner cover
Lint filter
Drain hose
Pulsator
Frame
Case
Spin tub
Plug Base
Water Inlet hose
Safety Cover If the picture of washing machine here is different from the real products,we are not going to change it. 1
BEFORE USING
ATTENTION
Warning:In case of the malfunction or breakdown of electrical parts & components,such as power cord,motors,capacitor,a professional after-sale service man must be called for the repairing purpose. Use 3-phase socket,the earthing should be well connected.
Pull out the plug while no power, move no use or cleaning.
Don't put it at damp place, like bathroom. Never clean it with water. Don't put the wet clothes on the control panel.
If the wire is destroyed, for safe, please ask our after -sale service technician to change or repair it. Keep the pins of the plug clean.
The water over 50
is forbidden.
50 C
Don't put your hand into the spin or wash tub while it is working even though it runs very slowly, especially take care of the children.
Don't separate it apart, repair or refit it by yourself.
Don't put any hot or heavy object on the machine.
The clothes with the volatile materials(such as thinner,fuel) is forbidden to wash.
The children without care or the handicapped are forbidden to use.
Keep the machine away from direct sunlight and heat source like the heater.
2
INSTALLATION & ADJUSTMENT
BEFORE USING
Please install and adjust your washing machine according to the reguirements of the instruction manual.It's important to your safe and correct operation of the washing machine.
The use of drain hose The hose should drain smoothly 1. The height of the hose should be less than 10cm, or it can not drain completely(down drain).
10cm
2. Maximum fixation height for hanging the hose(with a hook)over a drain outlet(eg.drain pipe,bath or sink)should not be higher than 1.2metres above the floor.(This is for pump drain model only)
Drain
3. Do not trample or press the hose.
Change the direction of the drain hose The ex factory installation position of the drain hose is shown in Figure 1. Back
The hose protrudes out from washing side. Lay down the machine on the soft object with its face towards the ground. Take the hose out from the fixing groove. (Figure 2) Along with the groove of the washing tub side, insert the hose with the step 1 to 3 and spread it to the washing side. (Figure 3) Insert the hose in the groove by hand, do not destroy the hose.
3
Soft object Front Figure 1
Soft object
Figure 2
Figure 3
BEFORE USING
MAIN FUNCTIONS
The comprehensive performance of the machine is excellent and its appearance is nice . As to the noise-proof design, the machine uses the enclosed base and low-noise motor which can lower the noise greatly. We assure you will have a quiet world when use it.
1.Rinse and foamremoving spinning 2.It can remove the extra detergent liquid and save time and water.
2.Hand washing Hand washing can improve the washing ability.
Preparation before washing 1.Install the inlet hose. The max water pressure permitted is 0.6mpa,the min is 0.03mpa. 2.Be sure the earthing is ok and insert the plug. And the earthing should not join with gas pipe or water hose. 3.Lay down the drain hose.(Down drain) 4.Put up the drain hose.(Up drain) 5.Please keep machine level, otherwise it will cause an abnormal sound.
Attention before washing The quantity of the Clothes should not exceed the rated value.The big clothes like jeans should be put in loosely.
Be sure of the special request of the clothes.
Take coins, sand and hairpins out of the clothes
When the pulsator is running, the buttons may cause sound. For safe, put the clothes with button in the middle of the cloth.
Fasten the buttons and the zippers.
4
WASHING ATTENTIONS USING PROCESS T he rated capacity of washing , spinning refers to the max weight of the dry clothes. The weight of the clothes to be washed should be below the rated capacity. The capacity will be affected by the thickness, size and type of the clothes. If the weight of the clothes is below 2kg,do not select the high water level, so as to prevent splashing of water.
Reference weight
Work clothes (1120g)
Underwear (70g)
Pajamas (200g)
Jacket (800g)
Shirt (300g)
Undershirt (180g)
Jeans (800g)
Coat (800g)
Blanket (900g)
Sock (50g)
Bedsheet (600g)
USE OF DETERGENT How to use the bleacher Fill the water to the specified level, and pour the bleacher into wash tub. The colourful clothes are apt to fade, so the bleacher is forbidden to use. The bleacher should not contact with clothes directly. The use of bleacher, refers to its instruction. The powder bleacher can be used after dissolved.
How to use washing powder Dissolved in the tub 1.Fill small quantity of water.. 2.Add some washing powder run for 30 seconds to dissolve it completely. 3.Put the clothes in and select the proper water level. Quick dissolving 1.prepare warm water of 30 and a container. 2.put the powder in and stir. The powder is more prone to pollute the clothes than the detergent,therefore please use it with proper quantity. For different powder, the dosage is different.
5
USING PROCESS
WASHING SEQUENCE Wash Inlet
1. Put the water inlet hose into the inlet,move the water inlet switch to wash side.
4.Select the program according to the clothes.
Wash timer
Program selector
2.Fill the water to the specified level and add dissolved washing powder
3.Put in the clothes, Please add the water if the water is not enough
6.After washing, set the selector to the "drain".
5.Select the wash time according to clothes.
Midway spinning 1.Put the clothes into the spin tub smoothly. 2.Spin. (1)Press the safety cover properly. Even though a few clothes, press the cover too. (2)Close the spin cover . (3)Spin for 1- 2 minutes. 3.Rinse and foam-removing spinning (1)Open the spin cover. (2)Put the inlet hose into the spin inlet and fill water for 1 minute. (3)Close the cover, spin for 1-2 minutes.
6
Spin timer
WASHING SEQUENCE
USING PROCESS
Rinsing Rinse(filling water) 1.Put clothes in the wash tub and select the suitable water flow according to the clothes. 2.Rinse Adjust the wash timer to 5-7minutes to do rinsing. Rinse with water (Repeat the midway spinning and rinse for 2-3 times.) 1.Put clothes in the washing tub and select the suitable water flow according to the clothes. 2.Fill water to the specified level. 3.Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the weight of clothes is below 3kg, use standard water flow. If you use the strong water flow,it may make water splash. Spray Rinse 1.Put the clothes into spin tub. 2.Move the water inlet switch to spin side. 3.Select the spin time as proper. Notes:You may repeat the above 1~3 steps to do more than once spray rinse.
Spinning 1.Put the clothes in spin tub smoothly. 2.Press the safety cover properly and close the spin cover
Selection of spin time Clothes
3.Spinning Select the spin time according to clothes and do spinning. While spinning, there may be abnormal sound. It is because clothes are not put properly, please switch it off, and arrange the clothes again. While spinning,open spin cover, spinning will stop; Close it, it will resume the spinning.
Spin time(mm)
Bedsheet, blanket
About4~5
Underwear(knitwear)
About2~4
Sweater(fabric)
About1~2
Thin clothes
Within 1
To do spinning and draining or rinsing(filling water) together,please first do spinning for about 1 minute,then do draining or rinsing, otherwise the spinning will stop owing to too much water stored in the spin tub.
7
AFTER USING After washing, clean the lint and foreign objects on the lint filter and the frame, or it will affect the next use. Before cleaning, pull the plug out.
Clean lint filter During washing,the lint-filter must be used. Be sure to clean it after use. 1.Take the filter down. Put your hand on the groove, press it and take it down. 2.Cleaning When the lint is wet, put it into the water and clean. 3.Install the filter After cleaning, insert the filter into the frame, and press in its upper part.
Clean the machine Clean machine with soft cloth. Clean with neutral detergent if is too dirty. Never wash it directly with water. After washing, take off the water inlet hose. Pull out the plug, hang up the wire. Do not keep water in wash tub for a long time. After washing, drain immediately. Clean the outside and inside of the machine with soft cloth. Open upper cover and close it again after 1 hour . Hang up the drain hose well.
When the remained water is frozen Prevent the freezing(after washing, drain water completely) After complete draining,set the program/drain selector to the strong or standard position. If it is on the drain position, ice is hard to melt When the water is frozen. Pour water below 50 degree into wash tub to soak.Then turn the pulsator with your hands gently until it can drain, After that,you can use it again.
8
C
2-3 L
TROUBLE-SHOOTING If there is something wrong with the machine, pull plug out before checking. Some phenomena may be not faults. Before repair, be sure again. If sure, contact with the repair station or after-sale service department. Do not repair by yourself. Reason
Phenomena The machine dose not work
Power is failure or not Plug is in or not Pulsator is twisted or not
The draining does not work
Drain hose is put down or not Drain hose freezes or not Drain hose is blocked or not There is clothes outside of spinning tub or not
Abnormal noise during washing
There are hairpins, coins, or metal items in washing tub or not
Abnormal noise and violent vibration during spinning
Machine is level or not Press in the safety cover smoothly or not Clothes is in the outside of the spinning tub or not . Clothes is too much in the spin tub or not
Some water flows from the drain hose in the first use
It is the water remained in the factory inspection of performance.
NOTE 1.Maximum pressure allowed at the water inlet:0.6Mpa 2.Minimum pressure allowed at the water inlet:0.03Mpa 3.The new hose-sets supplied with the appliance are to be used and that old hose-sets should not be reused.
WARNING 1.If the supply cord is damage,it must be replaced by the manufacturer or its service agent or similarly qualified persons in order to avoid a hazard. 2.For washing machine with ventilation openings in the base,that a carpet must not obstruct the opening. 3.This appliance is not intended for use by persons(including children) with reduced physical,sensory or mental capabilities or lack of experience and knowledge,unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 4.Children should be supervised to ensure that they do not play with the appliance.
9
