Transcript
20M H20 DIVABLE CONFIG
PROTECTION FROM WITHIN
The C4OPS System configured with the C4OPS Maritime Headset Config (P/N: SHS0003-17) and MBITR 10 pin radio adaptor (P/N: CA0035-00) is 20m immersible. C4OPS Maritime Headset Config (P/N: SHS0003-17) Helmet Clip
Headband
MICRO C4OPS
Acoustic Tube
C4OPS
C4OPS FAST GUIDE FAST GUIDE
Tighten battery cover
Micro C4OPS External Battery Compartment (P/N: CA0234-00)
MBITR 10 pin radio adaptor (P/N: CA0035-00)
MBITR 10 pin radio adaptor (P/N: CA0035-00)
NOTE: Prior to diving, disconnect all other radio adaptors and attach diving caps.
Acoustic Tube for Covert Monitoring
Helmet Clip
CONFIGURATION NOTICE: This document contains operational information related to the Silynx C4OPS® Headset. The information contained herein is for the operation and support of the C4OPS® Headset. PROPRIETARY NOTICE: This document contains information that is proprietary to Silynx Communications, Inc. It is furnished solely for operation and support purposes and is not provided for reprocurement purposes. All reprocurement and manufacturing rights are expressly reserved by Silynx Communications, Inc. and no such use may be made of this document, either directly or indirectly, without the prior written consent of an authorized official of Silynx Communications, Inc.
CONNECTING EARMUFFS
SILYNX COMMUNICATIONS, INC PUBLISHED AND CONFIDENTIAL WORK Fast Guide - DOC-USM000011 - Rev 06, April 2015 ALL RIGHTS RESERVED COPYRIGHT:
C4OPS Control Box
Peltor/ Sordin Headset Adaptor P/N: CA0015-01
Earmuff
www.silynxcom.com 1.866.325.1731 |
[email protected] 9901 Belward Campus Drive Suite 150 Rockville, MD 20850
SETTING UP
OPERATING C4OPS®
GETTING STARTED
BASIC FUNCTIONS
MOUNTING THE CONTROL BOX
PAIRING DUAL WIRELESS PTT [DWPTT] (2) Press & hold pairing keys 3 sec
C4OPS In Ear Headset Zipties Molle Clip Basic In Ear Headset (Blocked Connector)
(+) Hear Thru High Sensitivity
Hybrid Headset (Boom Mic Connector)
(+) Volume
(1) Press & hold
(-) Volume (-) Hear Thru Low Sensitivity/ Hear Thru Off
Zipties
Secondary PTT
Primary PTT (1) Connect Headband Boom Mic
“Pairing Activated” Beeps 30 sec
Ops Core Chinstrap Boom Mic
INSERTING EAR BUDS
NOTE: If
C4OPS Control Box
* (2)
Primary Radio Lead
(6)
“Pairing Successful”
“Pairing Failed” repeat the steps above.
HEAR THRU LEVEL
(5) Tighten
VOLUME LEVEL Off/ On/ Volume Level
(3) High Sensitivity
Secondary Radio Lead
Connect
Connect Shell Ear Retainers Intercom Cable Adaptor
Low Sensitivity/ Hear Thru Off
Keep mic exposed
(4) Attach
NOTE: In windy conditions reduce “Hear Thru” Attach collar clip.
Hang In Ear Headset on your ear.
Squash foam ear plug.
Pull upper ear up and back and push the ear bud firmly into the canal.
Press ear bud until foam ear plug expands.
VOICE PROMPT VOLUME LEVEL
(2) Press & hold 3 sec to confirm Tighten nape slider.
Peltor/ Sordin Headset Adaptor
CHANNEL SELECTION
Maritime Headset Config
(2) (+) Volume
Position ear retainer.
(1) Press until you hear “Voice Prompt Level”
(1) Press until you hear “Channel Selection” (2) Press & hold 3 sec to confirm
EAR BUD LEAK TEST *1.5V AA Lithium battery NOTE: No battery needed if using MBITR side connector.
(2) (-) Volume
C4OPS CONTROLS Rotary Knob Off/ On/ Volume Level
EXTRAS PTT3 / Hot Key
(+) Primary PTT
Secondary PTT
Mode
TROUBLESHOOTING: (1) Turn MBITR on. Enable MBITR side connector.
(-)
(2) Turn C4OPS on.
(3) MBITR is auto set to external audio and keypad locked.
In high noise, such as aircraft/vehicles, you may hear whistling. Press (-) until the sound disappears. If the problem continues, reinsert the ear buds and make sure you pass the sealing test.
(4) Ear plug sealing test will begin. VP “C4OPS 2X Beep”
(5) Press & hold 3 sec
OR No
= Pass
“Leak Right”
“Extras”
“Leak Left”
VP “Leak Both”
Leak = Reinsert ear plugs / replace ear plug size.
VP = Voice Prompt
= Important
